Table of Contents
Advertisement
Make sure that all unused glands or gland holes are sealed. There are two different size cable glands used
on the device. Follow the illustration below to achieve desired EMC protection with the EMC glands:
Cable gland M25 for 11-16 mm cable diameter
Please follow these instructions when routing cable via a cable gland:
1. Partially expose the braided screen by removing the outer sheath of the cable at a length of approx.
10 mm.
2. Insert the cable through the dome nut and the gland body until the contact spring is pressed against
the braided screen.
3. Firmly screw on dome nut.
© Obelux Oy 2017
Obelux Oy, Kutomotie 6 B, 00380 Helsinki FINLAND
Technical information in this document is subject to change without notice.
MI SERIES – Manual (v1.7)
Page: 10(28)
Advertisement
Table of Contents
