Before Using Your Refrigerator - Whirlpool ET180K Use & Care Manual

No-frost refrigerator-freezer
Hide thumbs Also See for ET180K:
Table of Contents

Advertisement

Before Using Your Refrigerator
1. Clean it
Clean your refrigerator before using it. See
cleaning instructions on page 10.
2. Plug it in
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended
that a separate circuit
serving only this appliance be provided. Use a re-
ceptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.
See Electrical Requirements
and Grounding
Instruction Sheet in your Literature Package.
3. Install
properly
.
.
-
1. Allow 3 inches (7.5 cm) between overhead
cabinets and the refrigerator top.
2. Allow at least 1 inch (2.5 cm) between the
refrigerator condenser on the back and the wall.
3. Allow YZ inch (1.25 cm) on each side of the
refrigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
5. If your refrigerator has an ice maker, make sure
ice maker water supply has been connected.
Refer to Installation Instructions.
Leveling screw
'
4. Level refrigerator-freezer
1. To raise front, turn screw in direction shown.
2. To lower front, turn screw in direction shown.
3. Check with level.
Use screwdriver
Right to raise;
to adjust
left to lower.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents