MaxLite CID1 Operating Instructions

Operating Instructions
MaxLite Hazardous Location Emergency Light – CID1
®

General Safety Information

• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon this
equipment, please follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• Make sure that the supply voltage is the same as the luminaire voltage.
• Do not install where the marked operating temperatures exceed the ignition
temperatures of the hazardous atmosphere.
• Do not operate in ambient temperatures above those indicated on the luminaire
nameplate.
• All gasket seals must be clean and undamaged.
• To ensure safety, a safety rope can be used to fix the luminaire before installation.
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
• Luminaire must be supplied by a wiring system with an equipment grounding conductor.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from
carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can
burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS. Models: HL-LI Series Emergency Backup Models
Operating characteristic:
Rated Voltage: 120-277 Vac
Ambient Temperate Range: -20°C (-4°F) ~ +45°C (113°F)
Charge time 24h, Discharge time 1.5h, Rated load 6W
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
MaxLite Hazardous Location Emergency Light – CID1
This fixture is suitable for use in the following
hazardous (classified) areas as defined by the
National Electrical Code (NEC) and Canadian
Electrical Code (CEC):
Hazardous Locations
Class I, Division 1, Groups C, D
Compliances
UL 844
UL 924
CSA C22.2 No.30-1986
CSA C22.2 No.137-M1981
CSA C22.2 No.250.0
CSA C22.2 No.250.13
Refer to the luminaire nameplate for specific classification
information, maximum ambient temperature suitability and
corresponding operating temperature (T-Code).
Picture is for illustration purposes only.
Your model may vary.
Page: 1
REV: 09/22/20