MaxLite CID1 Operating Instructions

Operating Instructions
MaxLite Hazardous Location Linear Light - CID1
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
• Make sure that the supply voltage is the same as the luminaire voltage.
• Do not install where the marked operating temperatures exceed the
ignition temperatures of the hazardous atmosphere.
• Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
• All gasket seals must be clean and undamaged.
WARNING:
RISK OF ELECTRICALSHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
• Luminaire must be supplied by a wiring system with an equipment grounding conductor.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from
carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can
burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
HL-LI2440!@#$$P-D1
Models:
HL-LI4880!@#$$P-D1
! = U, H (U=100-277V, H=277-480V)
@ = [blank], N, T ([blank] =wide, N = narrow,
T= Type II distributions)
# = [blank], D ([blank] =clear, D=diffused lenses)
$$ = [blank], 40, 30 ([blank] =5000K, 40=4000K,
30=3000K Color Temperatures)
Followed by suffix P-D1
Operating characteristic:
Rated Voltage: 100-277 Vac or 277-480 Vac, 50/60Hz
Ambient Temperate Range: -40°C (-40°F) ~ +60°C (140°F)
T-Code Class I Division 1,
Groups C, D
Class I Division 2,
Groups A, B, C, D
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
T6
T3C
MaxLite Hazardous Location Linear Light - CID1
This fixture is suitable for use in the following
hazardous (classified) areas as defined by the
National Electrical Code (NEC) and Canadian
Electrical Code (CEC):
Hazardous Locations
Class I, Division 1, Groups C, D
Class I, Division 2, Groups A, B, C, D
Compliances
UL 844
UL 1598
UL 1598A
Refer to the luminaire nameplate for specific classification
information, maximum ambient temperature suitability and
corresponding operating temperature (T-Code).
Picture is for illustration purposes only.
Your model may vary.
Environmental Ratings
Suitable for hazardous
location.
Page: 1
REV: 10/29/20