Cypress Semiconductor PSOC 62S2 Wi-Fi BT PIONEER KIT Quick Start Manual

PS C
®
O
• Before starting, ensure you have the following.
• PC with USB port
• UART terminal software such as Tera Term
or Minicom
• Visit the kit website to download and install the
required software
• Ensure the jumper J14 is at position 2-3 to select 3.3V
• Connect the KitProg3 USB connector (J6) to your PC
• Wait for the drivers installation to complete
CY8CKIT-062S2-43012 QUICK START GUIDE
62S2 Wi Fi BT PIONEER KIT
1
Kit Contents:
1 PSoC® 62S2 Wi-Fi BT Pioneer Board
2 USB Type-A to Micro-B cable
3 Four jumper wires (four inches each)
4 Two jumper wires ( ve inches each)
5 Quick Start Guide (this document)
www.cypress.com/CY8CKIT-062S2-43012
• Open the UART terminal software and connect to
the kit's USB-UART COM port with the settings
– Baud rate: 115200, Data: 8 bit, Parity: None, Stop
bit: 1 bit, Flow control: None
• Press the XRES switch (SW1) to reset the device
• Follow the instructions displayed on the UART
terminal to use the pre-programmed code example
Refer to the Kit Guide available at the kit website
for details.
2