Axis M11-E Series User Manual page 13

AXIS M11-E Series
Additional settings
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera's webpage
1. Go to Settings > System > I/O ports.
2. Give the input module a descriptive name.
3. To make the PIR detector send a signal to the camera when it senses motion, select Closed circuit in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create a rule in the camera's
webpage.
Send an email automatically if someone spray paints the lens
1. Go to System > Detectors.
2. Turn on Trigger on dark images. This will trigger an alarm if the lens is sprayed, covered, or rendered severely out of focus.
3. Set a duration for Trigger after. The value indicates the time that must pass before an email is sent.
Create a rule:
1. Go to Events > Rules and add a rule.
2. Type a name for the rule.
3. In the list of conditions, select Tampering.
4. In the list of actions, select Send notification to email and then select a recipient from the list. Go to Recipients
to create a new recipient.
To create a new recipient, click
5. Type a subject and a message for the email.
6. Click Save.
. To copy an existing recipient, click
13
.