Make Gas Connection - Whirlpool W10325493A Installation Instructions Manual

9. Open the broiler door. Use a
leveling legs one-half turn. Use a wrench or pliers to lower the
front leveling lets one-half turn.
A. Rear leveling leg
B. Front leveling leg
10. Adjust the leveling legs to the correct height. Leveling legs
can be loosened to add up to a maximum of 1" (2.5 cm). A
minimum of " (0.48 cm) is needed to engage the anti-tip
bracket.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
1. Remove grates.
2. Lift the cooktop by both front corners until the side support
rods snap into place.
" drive ratchet to lower the rear
B
A
A. Rear leveling leg
B Front leveling leg

Make Gas Connection

11. Move range into its final location making sure rear leveling leg
slides into anti-tip bracket.
12. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
13. Continue installing your range using the following installation
instructions.
3. Locate gas pressure regulator inside the burner box.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
4. All connections should go over and through the burner box
and follow down the range back.
A
7