Epson M200 Series Service Manual page 51

M200 / M205 / M100 / M105 Series
Wireless LAN Module (M205/M105 Series)
Wireless LAN Module Cable
Cover with acetate tape (x2).
Wireless LAN Module
Wireless LAN Module Cable
Attach two pieces of acetate tape on the Wireless LAN Module
cable to cover the cable to protect it as shown above.
Rear of printer
Cam
Paper Back Lever
LD Roller Assy
Install the LD Roller Assy with the following condition in order to avoid the Change Lever and Paper Back Lever.
Using a screw driver or the like, hold the Paper Back Lever to the rear as shown above not to let it touch the LD Roller Assy.
Push the Change Lever to the front to keep it in the hole of the Main Frame.
Disassembly/Reassembly
PF Grounding Spring
Left PF Grounding
Cutout
Spring leg B
Spring leg B
Main Frame
Frame Base
Assy
When installing the PF Grounding Spring, follow the procedure below.
1. From the left side of the printer, insert the spring leg A of the
PF Grounding Spring into the hole of the Frame Base.
2. Insert the spring leg B of the PF Grounding Spring into the
groove of the Frame Base.
3. Attach the spring leg B of the PF Grounding Spring to the
cutout of the Main Frame to install the PF Grounding Spring.
LD Roller Assy
Change Lever
Main Frame
Detailed Disassembly/Reassembly Procedure for each Part/Unit
PF Scale Sheet
Spring leg A
Spring
PF Scale Sheet Align the corner of Main Frame.
PF Grounding
Spring
Insert spring leg
A into groove.
Hole
Align the edge of Frame Base.
Attach the PF Scale Sheet to the Main Frame according to the
standard indicated in the figure above.
Align the screw holes of Main
Frame and PF Motor Frame.
4
PF Motor Frame
Before installing the Main Frame Assy, shift the Change Lever back to the rear.
When installing the Main Frame Assy, make sure of the following.
• The Change Lever must not interfere with the Main Frame.
• The above shown ribs and grooves, positioning holes and dowels are correctly aligned.
• The section A of the Main Frame Assy is not deformed.
Tighten the screws in the order indicated in the figure above.
Spur gear / Extension Spring 0.137 /
Main Frame
Insert the outside the
LD Roller
rib of Frame Base.
Double-sided tape
Install Spur gear/Extension Spring 0.137/Clutch/LD Roller shaft as
shown in the figure above.
Main Frame Assy
Section A
3
1
Main Frame
Revision A
Clutch / LD Roller shaft
Spur gear
Clutch
Extension Spring 0.137
LD Roller Shaft
Change Lever must not
Main Frame Assy interfere with Main Frame.
2
Rib and groove
Positioning hole and dowel
C.B.P-TITE SCREW 3x10 F/ZN-3C (6 ± 1 kgf·cm)
C.B.S-TITE SCREW 3x6 F/ZN-3C (6 ± 1 kgf·cm)
51
Confidential