Programming Extra Controls; Naming An Owner; Removing Owner - Nevco MPCW-6 Instructions Manual

Naming an Owner

Step 1:Turn the control on, insert the System Key Management Overlay and
follow the prompts to enter the "618" model code.
Step 2: Insert the System Key in either hand-held switch socket.
Step 3: At the "Ready" prompt press "Set",
Step 4: Press "Owner Name"
Step 5: Cursor will appear, enter name desired. When finished Press "Yes"
Step 6: Save data, Press "Save Changes to System" and Press "Yes" to save, or
"No" to cancel. The Yellow LED on the System will illuminate indicating
the data is being saved.
Step 7: Exit the system, Press "Quit" key, Press "Yes", Turn control off and
remove System Key.

Removing Owner

Step 1:Turn the control on, insert the System Key Management Overlay and
follow the prompts to enter the "618" model code.
Step 2: Insert the System Key in either hand-held switch socket
Step 3: At the "Ready" prompt press "Remove Owner", Display will read, "Delete
all Group and Receiver Data on this Control? Press "Yes" or "No"
Step 4: Pressing "Yes" will clear the control of all data.
Step 5: Exit the system, Press "Quit" key, Press "Yes", Turn control off and
remove System Key.
To program extra MPCW-6 controls follow these steps.
Step 1: Turn control on and insert "System Key Management" Overlay
Step 2: Enter Model Code 618
Step 3: Insert System Key in either hand-held switch socket. All data from the
System Key will be transferred to the new control.
Step 4: At the "Ready" prompt save data, Press "Save Changes to System" and
Press "Yes" to save, or "No" to cancel. The Yellow LED on the System
Key will illuminate indicating the data is being saved.
Step 5: Exit the system, Press "Quit" key, Press "Yes", turn control off and
remove System Key.
.
Programming Extra MPCW-6 Controls