Set Up; Naming The Receiver - Nevco MPCW-6 Instructions Manual

Step 1
Plug the System Key into the receiver using the phone jack.
Step 2
Plug receiver into the power adapter.
Plug the power adapter into any 120 volt 50/60 hertz outlet.
The Yellow LED on the System Key will illuminate indicating data is being
downloaded. The Green LED on the System Key will illuminate indicating the
data has been transferred. Disconnect the System Key from the receiver.
Repeat this step for all receivers that you will be installing at this time. The
data from the receivers will be stored in the System Key in the order they were
connected. Very Important: Label or identify in some manner where these
receivers will be installed. You may use the blank space provided on the
label located on the top of the Receiver. This information will be critical
when naming them in a subsequent step. Note: Only connect the System
Key to each Receiver once.
Step 3
Connect the MPCW-6 to its power adapter and plug into any 120 volt 50/60
hertz outlet. Unplug any hand-held switches before continuing with the set
up. Turn on the MPCW-6. On the MPCW-6 enter the 618-model code from
the overlay.
You will be prompted to "Insert the System Key" into either hand-held
switch socket. The Yellow LED will flash on the System Key and the display will
read "Downloading Data". Once completed, the green LED on the System Key
will illuminate indicating the data has been transferred to the control. You are
now ready to Name the Receivers.
Very Important: The System Key should remain plugged into the MPCW-6
until the set up procedure is complete, you will be instructed to remove the
System Key at the proper time.
Step 4

Naming the Receiver.

With new equipment, the display will read, "Unnamed Receiver," the
receiver must be given a name. This will be the first receiver that was connected
to the System Key. The receivers will appear in the same order they were
entered. The blinking curser is your prompt to enter the name you wish to give
this receiver. Type in the name using the letter keys on the left keypad or the
number keys on the right keypad, or a combination of both. Example: Pressing
the key labeled "A B C" once will display an "A", pressing the key again will
display a "B", etc. When entering the name of the receiver, enter each letter or
number. Note: If two consecutive letters in the name are on the same key, you
will need to use the "Right Arrow" key to advance the cursor. The "Left Arrow"
key corrects an error; continued pressing of the "Left Arrow" key will continue to
backspace. Press "Yes" when done. If valid, display will acknowledge and
Set up of MPCW-6