Create A Group; Add Receivers To A Group; Confirming The Set Up; Saving Changes To The System - Nevco MPCW-6 Instructions Manual

confirm receiver by displaying "Name Accepted". When choosing a name for the
receiver you will want to select the equipment by a name that is easily
recognizable by anyone who might operate the equipment. This procedure will
need to be done for each Receiver until the display indicates "Ready".
Note: Once all Receivers are named you may press the "No" key to escape
to the main functions, such as Create a Group or Select a Group.
Step 5

Create a Group

Press the "Create Group" key. The display will read "New Name" then the
cursor will appear in the display. Select a name that is easily recognizable and
basic. In a High School gym you might choose "Varsity Bskball." This group
would include all the equipment that is used in a varsity game. You might choose
"Freshmen Bskball." This group might include only the scoreboards and
equipment used during a freshman game. Enter the "Group Name" in the same
manner used to name the receiver, above. Press "Yes" when done. The display
will read "Name Accepted" then "Ready".
Step 6

Add Receivers to A Group

The receivers named in Step 3 now must be added to the group created in
Step 4. Press "Select Group." If only one group has been created, that name will
be displayed. If there are multiple groups in the system, press the "Select Group"
key until the group you wish to add the receivers to is displayed.
Press "Add Rcvr." The name of a receiver will be displayed, if you wish to
add this receiver to this group press "Yes." The display will read
"Receiver Added." Continue adding receivers as desired. If a receiver is
displayed that you do not wish to add to the group, press "Add Rcvr" again, the
next Receiver will be displayed. If all receivers in the system have been added to
a group, the display will read, "There are no valid receivers for this function.
Press any key to continue" Press any key to return to the "Ready" prompt.
Step 7

Confirming the Set UP

Press "Select Group." Group name(s) will be displayed, continue
pressing key to select the group you wish to review. Press "Show Group
Rcvrs." Continue pressing the "Show Group Rcvrs" key and all the
receivers included in your selected group, will be displayed followed by
"End of List." Do not skip this step.
Step 8

Saving Changes to the System

Press the key "Save Changes to System." Display will read "Do you want
to save data to the System Key? Yes or No", Press "Yes" The display will read
"Saving System Data" and the Yellow LED on the System Key will flash. When
the data transfer is completed the Yellow LED will stop flashing. The display will