Changing The System; Adding Or Deleting Receivers; Exiting The System - Nevco MPCW-6 Instructions Manual

read "Data Saved. Press any key to continue". After pressing any key the display
will return to "Ready."
Step 9

Exiting the system.

Press the "Quit" key on the overlay, display will read "Do you want to Quit, Yes or
No" Press "Yes" the display will prompt you to turn the control "Off" and remove
the System Key.
If any changes have been made to the System you will be prompted to "Save
Changes".
After all equipment is programmed, install the receivers per the Scoreboard
Installation Instructions. Proceed with the operational testing.
The following procedures require the use of the MPCW-6 Control, System
Key Management Overlay, the 618 Model Code and the System Key. No Hand-
Held Switches should be plugged into the control when making changes to the
system.
For more detailed information concerning the following procedures, refer
to the corresponding steps in the MPCW-6 Set Up.

Adding or Deleting Receivers.

Add a New Receiver
Step 1: Connect System Key to the Receiver, plug power adapter to receiver
and plug into any 120 volt outlet. The data will be transferred to the
System Key.
Step 2: Turn the MPCW-6 on; enter 618 Model Code and follow prompts to
Insert System Key to either hand-held switch socket. The Data will be
downloaded to the control.
Step 3: The display will prompt you to name the new Receiver(s).
Step 4: Select the Group or Create a new Group.
Step 5: Add the new Receiver(s) to the desired Group.
Step 6: Confirm that the new receiver(s) is/are now in the proper Group.
Step 7: Save the data to the System Key by pressing the "Save Changes to
System" key.
Step 8: Exit the system, Press "Quit" key, Press "Yes", turn control off and
remove System Key.

Changing the System

Adding or Deleting Receivers
Adding or Deleting Groups
Changing Receiver or Group Names
Removing Receivers from Groups
Naming or Removing Owner Name