Broiling - Whirlpool SF310PEA Use And Care Manual

Adjusting the oven temperature control
Oven temperature controls will gradually
shift after years of use. So, even though
your new oven is properly adjusted to
provide accurate temperatures, it may cook
faster or slower than your old oven.
If, after using the oven for a period of time,
you are not satisfied with the temperature
settings, you can adjust them by following
these steps:
1.
2.
3.
4.
5.
Make sure
the Oven Temperature
Control Knob is turned to the off position.
Pull
knob straight off and
flip it
over.
Loosen the locking screws inside the
control knob.
Note the position of the
notches.
To lower the temperature, hold
knob
handle firmly and
move
the tooth a notch
clockwise.
Each notch equals about
20°F
(11 "C).
To raise the temperature, hold
knob
handle firmly and
move
the tooth a notch
counterclockwise.
Each notch equals
about 20°F (11°C).
Tighten
the locking screws and
replace
the control knob.
To lower
Broiling
The broiler drawer is located below the oven
door.
Always broil with the oven door
closed.
1.
Pull the broiler drawer open and
tilt
the
door panel down.
2. Place
broiler pan grid so grease can
drain down ribbing and through slots into
lower part of the broiler pan. See picture.
3. Before the broiler is turned on, place
food on broiler pan and
position
the
broiler pan at one of the three levels.
4. Close broiler drawer.