Using Your Range; Using The Surface Burners - Whirlpool SF3020ER Use & Care Manual

Using your range
LEFT FRONT
LEFl REAR RIGHT FRONT RIGHT REAR
CONTROL KNOB CONTROL KNOB
CONTROL KNOB
CONTROL KNOB
/
SURiACE
OVEN TEMP
BURNER
CONTROL KNOB INDICATORS
Using the Surface Burners
These ranges are equipped with either standing pilots or electronic igniters.
Standing pilots must be lit initially with a match following the directions on
page9. The pilot light will remain lit when the burners are turned off. To turn a
burner on again, just push in and turn the control knob to LITE and the burner
will light. Electronic ignitors automatically light the burners each time they
are used.
Control knobs must be pushed in,
then turned to LITE position. On elec-
tronic ignitor models, the clicking
sound is the ignitor sparking.
After the burner lights, turn the control
knob back to a desired setting. The
control knob can be set anywhere
between HI and OFF Do not cook
with the control In the LITE position.
Surface Burner Indicators
The solid dot in the surface burner
indicator shows which surface burner
is turned on by that knob.
In Case of
a
Prolonged Power Failure
Surface burners with electronic ignitors can be manually lighted. Hold a lit
match near the burner and turn the control to the LITE position. After the burner
lights, turn the control to the desired setting. Power failures will not affect Stand-
ing Pilots.