ADDER RC1 Installation And Use Manual page 23

The hotkey command are summarised below (note that the numbers on the numeric
keypad do not form part of a valid hotkey) :
'HOTKEYs' and '1' - selects channel 1
'HOTKEYs' and '2' - selects channel 2
'HOTKEYs' and '3' - selects channel 3
'HOTKEYs' and '4' - selects channel 4
'HOTKEYs' and 'TAB' - selects the next channel. The next channel may be the next
active channel or the next channel in numerical sequence depending upon the
position of option switch 8 (see section 2.4.3).
'HOTKEYs' and 'A' - selects autoscan mode where each channel's video is
displayed for the selected time (see section 2.4.2). To cancel autoscan mode simply
select any fixed channel either by hotkey or by using the front panel button.
'HOTKEYs' and '0' – switches off the video signal and displays 0. This will cause
some monitors to go into standby mode or switch off. The video signal can be re-
enabled by selecting a channel.
Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To select channel 2:
ba 2 ba
press
To 'tab through' channels:
ba v ba
press
release
AdderView USB
2
release
v
release
v v v v
press
Installation and Use
2 ba ba
2
v v v v
press
vba vba
release
Page 22