Table of Contents
Advertisement
8. Push the Up button to set the
desired stop time. AUTO will
appear on the display and the clock
will automatically calculate the
start time. When the desired start
time is reached, the Oven Indicator
Light will come on indicating that
the timed bake cycle has begun.
9. When the desired stop time is
reached the Oven Indicator Light
will go off, a lo-second tone will
sound and the display will return to
Hot air and moisture escape from the
the current time-of-day. The AUTO
oven through a vent located at the back
liaht will flash on and off until the
of the cooktop.
C"&cel/Clock button is pushed. The
Do not block the vent. Poor baking can
oven will shut off automatically.
result.
10. After baking is done or to stop the
oven before preset time, push the
Cancel/Clock button and turn both
the Oven Selector and the Oven
Temperature Control to OFF.
To avoid sickness and food waste
when using the Cook Timer:
. Do not use foods that will spoil
while waiting
for cooking to start,
such as dishes with milk or eggs,
cream soups, and cooked meats or
fish. Any food that has to wait for
cooking to start should be very
cold or frozen before it is put in
the oven. MOST UNFROZEN
FOODS SHOULD NEVER STAND
MORE
THAN TWO HOURS
BEFORE COOEING STARTS.
. Do not use foods containing
baking powder or yeast when
using delay start. They will not
rise properly.
n
Do not allow food to remain in
oven for more than two hours
after end of cooking cycle.
Bum Hazard
When the oven is ON, pans and pan
handles left near the oven vent can
become hot enough to bum the
user and to melt plastics. Use pot
holders to move pans. Never store
plastics, paper or other items that
could melt or bum near the oven
vent, or any of the surface units.
L
The optional
backguard
accessory
An optional backguard accessory can be
added to the back of the cooktop. This
accessory (Part No. 4315467) is available
from your Roper Appliance dealer.
The storage
drawer
The storage drawer is for storing pots
and pans. The drawer can be removed to
make it easier to clean under the range,
and to check for installation
of the anti-
tip bracket(s). Use care when handling
the drawer.
Removing
the storage drawer:
Replacing
the storage dawer:
Drawer slide rail
1. Fit ends of drawer slide rails into
the drawer guides on both sides of
opening.
2. Lift drawer front and push in until
metal stops on drawer slide rails
clear white stops on drawer guides.
Lift drawer front again to clear
second stop and slide drawer
closed.
To verify
that the anti-tip
bracket(s)
is engaged:
. Remove storage drawer.
. Look to see if the anti-tip bracket(s)
is attached to floor with screws.
. Make sure rear leveling leg(s) is
positioned under bracket(s).
n
See "Important Safety Instructions"
on page 2 and Installation
Instructions for further details.
NOTE: The range will not tip during
normal use. Tipping can occur if
excessive force or weight is applied to
open door without anti-tip bracket(s)
properly secured.
1. Empty drawer of any pots and pans
before removing drawer. PulI
drawer straight out to the first stop.
Lift front and pull out to the second
stop.
2. Lift back slightly and slide drawer
all the way out.
Page 6
Advertisement
Table of Contents
