M-system R7G4FML3-6-DC16A Instruction Manual page 8

• Input /Output Data Details
Input Data: Slave stations -> master station readback value is set.
CH0 IN LO CH0 Data Low order 8 bits
CH0 IN HI CH0 Data High order 8 bits
CH1 IN LO CH1 Data Low order 8 bits
CH1 IN HI CH1 Data High order 8 bits
CH2 IN LO CH2 Data Low order 8 bits
CH2 IN HI CH2 Data High order 8 bits
CH3 IN LO CH3 Data Low order 8 bits
CH3 IN HI CH3 Data High order 8 bits
Output Data: Master station -> slave stations data is set.
CH0 OUT LO CH0 Data Low order 8 bits
CH0 OUT HI CH0 Data High order 8 bits
CH1 OUT LO CH1 Data Low order 8 bits
CH1 OUT HI CH1 Data High order 8 bits
CH2 OUT LO CH2 Data Low order 8 bits
CH2 OUT HI CH2 Data High order 8 bits
CH3 OUT LO CH3 Data Low order 8 bits
CH3 OUT HI CH3 Data High order 8 bits
CMD_CTRL
CMD_CTRL command area is following.
BIT FUNCTION
0 - 2 Reserve
3 ALM_CLR
4 - 5 Reserve
6 - 7 CMD_ID
8 - 15 Reserve
CMD_STAT
CMD_STAT response area is following.
BIT FUNCTION
0 D_ALM
1 D_WAR
2 CMDRDY
3 ALM_CLR_CMP
4 - 5 Reserve
6 - 7 RCMD_ID
8 - 11 CMD_ALM
12 - 15 COMM_ALM
Output data readback data bits 0 - 7 are set.
Output data readback data bits 8 - 15 are set.
Not in use
Not in use
Not in use
Not in use
Not in use
Not in use
Output data bits 0 - 7 are set.
Output data bits 8 - 15 are set.
Not in use
Not in use
Not in use
Not in use
Not in use
Not in use
REMARKS
Not used
0: Clear alarm/warning disabled
1: Clear alarm/warning triggered
Not used
Not used in the standard I/O command profile
Not used
REMARKS
Not used
Not used
1: Command reception enabled
0: Other
1: Completion of execution of ALM_CLR
0: Other
ALM_CLR_CMP can be cancelled by setting "0" for CMD_CTRL.ALM_CLR.
Not used
Not used in the standard I/O command profile
Warning 0: Normal, 1: Invalid data
Alarm 8: Unsupported command received, 9: Invalid data, A: Command ex-
ecution condition error, B: Subcommand combination error, C: Phase
error
Warning 0: Normal, 1: FCS error, 2: Command data not received, 3: Synchro-
nous frame not received
Alarm 8: FCS error, 9: Command data not received, A: Synchronous frame
not received, B: Synchronization time interval error, C: WDT error
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
R7G4FML3-6-DC16A
EM-7774-B Rev.2 P. 8 / 10