Using The Self-Cleaning; Before You Start - Whirlpool RS676PXL Use & Care Manual

Terminal
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle.
5. When the terminal is pushed into the re-
ceptacle as far as it will go, the surface unit
will fit into the reflector bowl.
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer
If a reflector bowl gets discolored, some
of the utensils used may not be flat enough.
Or some may be too large for the surface
unit. In either case, some of the heat that is
meant to go into or around a utensil goes
down and heats the reflector bowl. This ex-
tra heat can discolor it.
USING THE SELF-CLEANING CYCLE
The self-cleaning cycle uses very hlgh heat to burn awcy soil. Before
you start, make sure you understand exactly how to use the cycle
safely.
BEFORE YOU START
1.
Clean areas that may not be cleaned
during the cycle. Use hot water and deter-
gent or a soapy steel-wool pad on...
l
the frame around the oven
l
the inside of the door, especially the part
outside the oven seal.
DO NOT try to clean the flberglass seal. DO
NOT move It or bend It.
2. Remove any pots or pans you may have
stored in the oven. They can't stand the
ny loose soil or grease. This will
help reduce smoke during the cleaning
Clean Door
19