Table of Contents
Advertisement
Cleaning
and
caring
for your
range
Your range is designed to be easy to clean. You will usually wipe off
spills and spatters when they happen, but you will sometimes want to
clean under and behind the control knobs and surface units This section
L3
Off
will tell you how to remove those. and what to use when cleaning.
Removing
and replacing
surface
unit control
knobs:
$
1. Be sure the control knobs are set to "OFF"
-i
2. Pull straight out on the black knobs
%
3. If the control has a chrome trim ring, pull it straight out.
4. Wash the knobs (and trim rings) in warm, sudsy water.
5. Replace the trim rings first.
If the control
spring was removed,
put
it back exactly
as shown on the left...small
end first.
Pull knob
and trim
ring
6. Hold the black knob so it points to "OFF," Push it straight back on.
straight
out. Remember
Removing
and replacing
oven control
knobs:
how the spring
goes.
1. Be sure the knobs are set to "OFF"
2. Pull each knob straight off.
3. Wash the knobs in warm. sudsy water.
4. The knobs are not interchangeable. Make sure you put the
adjust-
able Oven Temperature
Control
Knob
on the right place, and the
nonadjustable
Oven Selector Knob on the other.
Removing
surface
units and reflector
bowls:
1.
First. be sure the Surface Unit Controls are all "OFF" and that the
surface units are cool.
2.
To remove
surface
unit,
lift and pull
straight
out.
3.
See where the surface units plug into the range? Lift each surface
unit about an inch (2.5 cm) at the edge away from the plug-in
(receptacle). Pull the unit straight away from the plug-in.
Do not
wash surface
units; they will burn themselves
clean during
nor-
mal use.
Lift out the reflector bowls.
12
Advertisement
Table of Contents
