Table of Contents
Advertisement
Cleaning
and
caring
for your
range
Your range is designed to be easy to clean. You will usually wipe off
spills and spatters when they happen. but you will sometimes want to
clean under and behind the control knobs and surface units. This section
will tell you how to remove those. and what to use when cleaning
Removing
and replacing
surface
unit
control
knobs:
1. Be sure the control knobs are set to "OFF"
2. Pull the black knobs straight off
straight
out. Remember
:3 If the control has a chrome trim ring. pull It straight off
how the spring
goes.
4 Wash the knobs (and trim rings) in warm, sudsy water
5 Replace the trim rings first.
If the control
spring
was removed,
put
it back
exactly
as shown
on the left..
small
end first.
6 Hold the black knob so it points to "OFF" Push it straight back on
Removing
and replacing
oven
control
knobs:
1 Be sure the knobs are set to "OFF"
2 Pull each knob straight off.
3 Wash the knobs in warm. sudsy water.
4 The knobs are not interchangeable. Make sure
you
put the
adjust-
able
Oven
Temperature
Control
Knob
on the right place. and the
nonadjustable
Oven Selector Knob on the other
To remove
surface
Removing
surface
units
and reflector
bowls:
unit,
lift and pull
1 First, be sure the Surface Unit Controls are all "OFF" and that the
straight
out.
surface units are cool.
2 ILIft each surface unit about an inch (2 5
cm)
at the edge away from the
plug-ill !receptacle) Pull the unit straight away from the plug-irl. Do
not wash surface units. they will burn themselves clear) during normal
u5e
13 Lift out the reflector bowls.
12
Advertisement
Table of Contents
