Related Manuals for Whirlpool RIE360B
Summary of Contents for Whirlpool RIE360B
- Page 1 TF&3001 30-INCHFREE-STANDINGUECTRICRANGE ModelRIE360B Control Panel Chrome Model and Serial Number Plate Automatic Oven Light Switch Storage Drawer...
-
Page 2: Using The Automatic
Oven Signal Light Oven Temperature Control Knob Table of Contents BEFORE USING YOUR RANGE USING THE SURFACE UNIT CONTROLS USING THE OVEN CONTROLS Baking Broiling Vanable Broil Fracture Resetting the OLcan Temperature Control Knob SETTING THE CLOCK TO THE CORRECT TIME OF DAY. USING THE MINUTE TIMER USING THE AUTOMATIC... - Page 3 Surface Unit Signal Light Surface Unit Control Knobs Before be sure you use your range as it was meant to be used. Before using it. you are personally responsible for making sure that it.. is properly installed and leveled on a floor that will hold the weight. and in a well-ventilated room is connected only to the right kind of outlet.
- Page 4 Using the surface them. This helps avoid turning them on accidentally when wiping off the Control Panel. And it helps keep small children from turning them on. You push in on them...then must (For example. [ . ] shows that the right front unit.. the one closest to you on your right..
- Page 5 sitions for different to BROIL. Food Beef Steaks Rare Medium Well done Beef Steaks Rare Medium Well done Hamburgers Lamb Chops Medium Ham slice. precooked ALWAYS broil with the or tendered door open about 4 Canadian inches (10 cm). Pork Rib or Loln Chop Well done Chlcken Fish...
- Page 6 Setting 1 Push in the Minute Timer Knob and turn it clockwise to set the hands to the correct time of day. 2 The Minute Timer hand will turn as you set the clock. When the clock is set. let the knob pop out. Then. while it is out. turn the Minute Timer hand Minute Timer.
- Page 7 Start 3. Push in and turn Time Knob clockwise to the time you want the oven start. 5. Turn the Oven Temperature Control Knob to the temper- ature you want to use to cook the food. When cooking is finished, Oven Temperature Control Knobs to “OFF.”...
- Page 8 Oven rack positions them to be until it stops. Then lift up the front edge and pull again. It will slide past the stops. out of the guides and out of the oven. the oven and slide it in. the stops in the rack guides. For: Baking Broiling...
- Page 9 The oven vent There is an oven vent under the right rear surface element. When the oven is on. heated air will escape through it. A vent is needed for air circulation in the oven during baking. You can cook on this surface unit while the oven is on.
- Page 10 Setting 1. Set the Oven to “CLEAN.” 3. The clock and stop time should all have the right time of day. Lock the oven door by moving the Lock Lever all the way to the right. the Clean the Clean Light doesn’t the lever start.
- Page 11 How the Self-Cleaning cycle work s: When oven contr& are set to “CLEAN.” than it does for cooking. This high heat causes soil on the inside oven walls to burn off, or break up and mostly disappear. While this is happening.
- Page 12 Special Cleaning spills and spatters when they happen. but you will sometimes want to clean under and behlnd the control knobs and surface units. This section will tell you how to remove those. and what to use when cleaning. Removing 1, Be sure the control knobs are set to “OFF.”...
- Page 13 Removing I ,\ 1. First. be sure the Surface Unit Controls are all “OFF” and that the Terminal 2. See where the surface units plug into the range? Lift each surface 3 Lift out the reflector bowls. To remove surface unit, lift and pull straight out.
-
Page 14: What To Use
PART WHAT TO USE Outside of Soft cloth, warm soapy water appliance Nylon or plastic scouring pad for stubborn spots Surface units No cleaning required Control knobs Warm. sudsy water and bnstle and chrome brush Chrome Automattc dishwasher or reflector bowls warm, soapy water or plastic scrubbing pad Warm. - Page 15 United States. help is lust a phone call away Whirlpool franchised TECH-CARE’ Whirlpool maintains a nationwide TECH-CARE service companies to fulfill your warranty and provide after- warranty seTvIce and maintenance to keep your WHIRLPOOL in peak condition. you follow these Instructions.) Cooking...
- Page 16 You can help your TECH-CARE service representative give you Your TECH-CARE service representative is specially trained in the Call Whirlpool Corporation in Benton Harbor at the COOL-LINE If you must call or write. please provide: your name. address. tle111o11 Harbor,...