Game Auditing Features; Game Assembly Procedures - Data East laser WAR Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

1. Lay carton on side with game cabinet bottom down. Remove all packing material (cabinet legs

are located in corner packing material). Slide game out of carton and remove parts package

from cash box. Locate 4 leg levelers and 8 leg bolts in parts package and attach leg levelers to

cabinet legs. Hex nuts on leg levelers must be on leveler before threading leveler in leg.

2. Support rear of cabinet and attach rear legs using 2 leg bolts for each leg.

3. Support front of cabinet and attach front legs.

4. Reach into opening at top rear of cabinet and extend power cord through opening and seat the

cord into pedestal slot. Raise the backbox ensuring no cables are pinched and temporarily

secure with clamp on rear of cabinet.

Game should not be moved with backbox secured by temporary clamp.

5. Remove backbox keys from clip inside of coin door and remove backglass. Open backbox

door and install 2 bolts with washers from parts package through holes in bottom of backbox.

Check all connectors for proper seating.

6. Remove playfield glass and raise playfield. Raise playfield support bar on inside right of cabinet

and insert tip of bar into notch on playfield. Check all cabinet cable connectors for proper

seating.

7. Remove plumb tilt, and small steel ball for ball roll tilt from parts package and install on panel

on inside left of cabinet.

8. With playfield in lowered position, check the side to side level of playfield and adjust leg

levelers as necessary. Check front to back incline of playfield and adjust leg levelers for an

incline of 6 to 7 Y2 degrees of incline. If incidence meter is not available, adjust front levelers for

lowest position and rear levelers so bottom of rear legs are approximately 2 inches from floor.

After levelers are adjusted, tighten hex nuts to bottom of legs (refer to

Specification Section).

Incline of playfield will affect difficulty of game play. Incline should be adjusted to recommended

setting.

9.' Check plumb and ball roll tilt and adjust if necessary.

There are 50 Audit Features that allow obtaining of information about coin intake and the effects

on game difficulty level due to game adjustments. The

Feature has a description that will be displayed in Players 1, 2, and 3, and a corresponding Audit

Number in the ball in play display. Player 4 will display the accumulated total for each Audit

Feature. To reset Audit Totals, refer to

46 (RESET AUDIT TOTALS).

TO ENTER GAME AUDITING FEATURES

With the game in the game over mode, and the FORWARD/REVERSE button in the Forward (up)

position, press the STEP button. Players 1, 2 and 4 will display the CPU Board Prom Identification

Number, shown as the first item in the

players 1, 2 and 3 will display the description of Audit Feature number 1. The credit display shows

AU and the ball in play display shows 01 for Audit 1. Use the STEP button to select the Audit Feature

desired. The FORWARD/REVERSE button determines whether the STEP button causes Audit

Feature numbers to increase or decrease.

GAME ASSEMBLY PROCEDURES

WARNING!!!!

N OTICE!!!!