Kenmore 134309800 Installation Instructions Manual page 6

LOCATION OF YOUR W LOCA LOCA TION OF YOUR W TION OF YOUR WASHER TION OF YOUR W
LOCA LOCA TION OF YOUR W
DO NOT INSTALL YOUR W DO NOT INST DO NOT INST ALL YOUR W ALL YOUR WASHER: ALL YOUR W
DO NOT INST DO NOT INST ALL YOUR W
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60 degrees F (15.6
degrees C) for proper washer operation.
2. In an area where it will come in contact with
curtains or drapes.
3. In an area (garage or garage-type building)
where gasoline of other flammables are kept
or stored (including automobiles).
4. On carpet. Floor MUST
maximum slope of 1/2 in. per foot (1.27 cm
per 30.5 cm). To ensure vibration or movement
does not occur, reinforcement of the floor may
be necessary.
IMPORT T T T T ANT IMPOR IMPOR ANT ANT
IMPOR IMPOR ANT ANT
MINIMUM INST MINIMUM INSTALLA MINIMUM INST ALLA ALLA ALLATION CLEARANCES TION CLEARANCES TION CLEARANCES TION CLEARANCES
MINIMUM INST MINIMUM INST ALLA TION CLEARANCES
When installed in alcove: Sides, Rear, Top = 0 in
(0 cm).
When installed in closet: Sides, Rear, Top = 0 in
(0 cm), Front = 1 in (2.54 cm).
Closet door ventilation openings required: 2 louvers
2 2
each 60 in (387 cm ) - 3 in (7.6 cm) from top and
bottom of door.
UNP UNP ACKING ACKING
UNP UNPACKING UNP ACKING ACKING
1. Cut the shipping carton along the dotted line
along the base of the unit.
2. While in the carton carefully lay the washer
on its back side.
3. Remove the styrofoam base.
4. Carefully return the washer to an upright
position and remove the carton.
5. Carefully move the washer to within 4 feet
(122cm) of the final location.
6. Remove the following from the back side of
the washer:
3 yellow plastic spacers,
ASHER ASHER ASHER
ASHER
ASHER: ASHER: ASHER:
ASHER:
MUST MUST
MUST be solid with a MUST
3 bolts,
BOLT
S PACER
"P" CLAMP
7. Remove the service panel from the front of the
washer.
8. Remove the 4 nuts and 6 large washers that
attach the 2 yellow shipping braces to the drum
and the base. Lift up on the drum and remove
the braces (a yellow ribbon surrounds the items
to be removed). These braces must be removed
to allow the power supply cord to be released
from the shipping ring.
9. Remove the large styrofoam block located under
the drum. Lift up on the drum, tilt the base of
the foam block inwards toward the rear of the
washer until free, then pull it out.
10. Remove and discard the yellow ribbon and label
from the front of the washer.
11. From the rear of the washer, carefully pull out
the power supply cord through the hole in the
backsheet.
12. Replace the service panel and screws.
NOTE: NOTE: NOTE: NOTE: NOTE: If the washer is to be transported at a
later
hardware must be reinstalled to prevent
shipping damage.
6
date, the shipping support