Using The Self-Cleaning Cycle - Whirlpool RF391PXW Use And Care Manual

Caring For Your Range
Continued
Hand lean frame
I
Hand clean door
around edge
Do not hand clean seal
3. To lower the cooktop, lift cooktop
from both sides while pressing the
support rods back to unlock them.
Lower the cooktop into place.
Using the Self-Cleaning cycle
The Self-Cleaning Cycle uses very
high heat to burn away so11 Before
you start make sure you understand
exactly how to use the Self-Cleanrng
cycle safely.
Before you start
1. Clean the areas shown by hand.
They do not get hot enough during
the Self-Cleaning cycle for soil to
burn away. Use hot water and
detergent or a soapy steel wool
pad on...
l
The inside of the door. (The center
area of the door does not need to
be hand cleaned.)
. The frame around tlie oven.
Do not clean, move or bend the
fiberglass seal. Poor cleaning and
poor baking will result.
2. Remove the broiler pan and any
pots and pans you may have stored
in the oven.
NOTE: The broiler pan (without grid)
can be cleaned in the oven only if most
of the soil has been removed by hand-
cleaning or a dishwasher. The chrome
broiler grid will discolor if cleaned in
the Self-Cleaning cycle.
3. Wipe out any loose soil or
grease. Thus will help reduce smoke
during the Self-Cleaning cycle.
4. If you want the oven racks to
remain shiny, remove from the
oven and clean by hand. Other-
wise. put oven racks on second and
fourth guides (guides are counted
from bottom to top). After racks are
20