Table of Contents
Advertisement
2. Use the Hour and Minute pads to set the
desired time. Push the "up" (A) or "down" (V)
pad(s) until the correct time shows in the
display.
3. Push the Start/Enter pad. The Minute Timer
will begin counting down immediately
after the
timer is started.
When time is up, "End" will show in the large
display and you will hear four 2-second tones.
You will also hear four 1 -second tones every
minute until you push one of the two Timer
pads.
NOTE: To disable the reminder tones, push
and hold the Timer Set pad for 4 seconds.
To reactivate the tones, follow the same
procedure.
To cancel
the Minute
Timer:
l
Push the Timer Cff pad. The time of day will
show in the display.
Using the Off/Cancel
pad
The Off/Cancel pad will cancel any command pad
except for the Timer Set pad. When the Cff/
Cancel pad is pushed, the display will show the
time of day or, if Minute Timer is also being used,
the time remaining.
Audible
signals
Audible signals tell you if a function is entered
correctly or not. They also tell you when a cycle is
completed.
To shut off all signals
except for the end-of-
timer tone:
1. Press and hold the Stop Time pad for 4
seconds.
2. A short tone will sound to tell you the signals
havebeenchanged.
Repeat the above steps to turn the signals
back on.
12
Advertisement
Table of Contents
