Download
Share
Print this page
  1. Manuals
  2. Brands
  3. CBS ArcSafe Manuals
  4. Controller
  5. RSK-AK11
  6. User manual

CBS ArcSafe RSK-AK11 User Manual

A portable actuator for remotely operating selected ge ak breakers
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
U S E R S M A N UA L
RSK-AK11
A Portable Actuator for Remotely
Operating Selected GE AK Breakers
CBSArcSafe.com |
Email: info@CBSArcSafe.com
Rev. September 2019
Arc
CBS
A Group CBS Company
| 877-4-SAFETY |
Safe
®
Fax: 940-382-9435
WE
WHAT STANDS
BETWEEN YOU
DO.
AND ARC-FLASH
DANGER ?

Advertisement

loading

Related Manuals for CBS ArcSafe RSK-AK11

Summary of Contents for CBS ArcSafe RSK-AK11

  • Page 1 Safe ® A Group CBS Company U S E R S M A N UA L RSK-AK11 A Portable Actuator for Remotely Operating Selected GE AK Breakers WHAT STANDS BETWEEN YOU AND ARC-FLASH DANGER ? CBSArcSafe.com | Email: info@CBSArcSafe.com | 877-4-SAFETY | Fax: 940-382-9435 Rev.

  • Page 2: Arc-Blast Hazards

    Safe ® A Group CBS Company User’s Manual for the RSK-AK11 model • 1.0 Arc-blast Hazards • 2.0 Safety Information 2.1 Finger pinch points 2.2 Strong magnets • 3.0 Battery Information 3.0 Battery Requirements 3.1 Battery Life 3.2 Battery Replacement 3.3 Connecting/Disconnecting Batteries...

  • Page 3: Operation

    Safe ® A Group CBS Company 2.0 Safety Information 3.3 To connect/disconnect batteries: ALWAYS connect the control cable to the actuator BEFORE installing the Chicken Switch®. 2.1 Finger pinch points Keep fingers clear of the bottom of the actuator when the actuator is near a ferrous surface. 2.2 Strong magnets The holding magnets are very strong.

  • Page 4: Sequence Of Operation

    NOTICE: An RSK-AK11 mounting bracket is required to be permanently installed on each breaker that is to be operated. Each RSK-AK11 ships with one mounting bracket. Additional brackets (P/N P-0235) can be ordered from MarTek Limited at 1-800-248-4958.
  • Page 5 Step 5: If breaker is not already charged, use the charging handle to charge the breaker before attempting to operate the breaker with the RSK-AK11. Step 2: Lift and remove the RSK-AK11 actuator from the mounting bracket and return the charging handle to the vertical, 6 o’clock position.
  • Page 6 Safe ® A Group CBS Company 4.4 The indicator lights & controls: NOTE: If either of the actuators are held in the extended position for longer than approximately 2 seconds the NOTE: Red and Green indicator lights only work actuator will de-energize and will remain in extended when the ENABLE button is depressed.

  • Page 7: Warranty

    3 amp PURPOSE. Power supply 8 AA alkaline disposable batteries. CBS ArcSafe® will, at its option and its cost (excluding When used properly, one set of batteries shipping expenses) repair, replace or refund the purchase should yield hundreds of operations.