Related Manuals for CBS ArcSafe RSA-138
Summary of Contents for CBS ArcSafe RSA-138
- Page 1 CBS ArcSafe® RSA-138 (For Allis Chalmers LBS-SE) P.O. Box 550 Argyle, TX 76226 (940) 382-4411 www.cbsarcsafe.com...
-
Page 2: Installation
DANGER! Ensure that the switch to be serviced matches the switch shown on cover. If the switch to be serviced does not match, please call CBS ArcSafe® for more information regarding remote switching applications for your particular model. 1. Remove the bolt located above the switch and replace it with the provided threaded stud as shown in the following pictures. - Page 3 6. Once again ensure that the tooling is fully engaged in the switching mechanism. 7. The RSA is now properly installed onto the switch. See the next section for the charging operation details. RSA-138 Installation and Operation Manual ® © 2010 CBS ArcSafe...
-
Page 4: Charging Operation
Please ensure that all cables are clear of moving parts. Failure to do so could damage cables and/or actuator. 3. Set the two position selector switch on the RSA-138 Interface Module to the setting labeled “Charging Motor.” 4. Power on the RSO-I AR. - Page 5 With the shaft disengaged, rotate it slightly to ensure that when it is released it will not engage the switching mechanism. 3. On the RSA-138 Interface Module, switch the two position switch to the setting labeled “Open/Close Actuator.” 4. Power on the RSO-I AR and ensure that the AR function is “ON.”...
- Page 6 RSA-138 Parts List Item Description Part Image RSA-138 Assembly RSA-138 Interface Module RSA-138 Cabinet Attachment Stud & Pin RSA-138 Replacement Tooling & Pin...
- Page 7 P.O. Box 550 Argyle, TX 76226 Tel: 940-382-4411 Fax: 940-382-9435 Website: www.CBSArcSafe.com Email: info@CBSArcSafe.com DANGER! *Ensure that personnel using this equipment are adequately trained in the operation of the switchgear they are planning to work with; that they are correctly stationed outside the arc flash boundary;...