Allen-Bradley ControlNet 1786-6.2.1 Planning And Installation Manual page 43

3. Lock the cable into place by moving the chamber-gauge ring
forward until it meets the cable with slight resistance.
4. Holding the cable in one hand, place the index finger of your other
hand inside the chamber-gauge ring and turn the strip tool 360°
around the cable. Make 4 or 5 full rotations until the strip tool glides
easily around the cable.
Continue repeating steps 3 and 4, moving the
chamber gauge ring forward one notch for each time
you repeat the steps, until you reach the last notch.
Each time you move the chamber gauge ring forward
a notch, the strip tool makes a deeper cut into the
cable.
Important: On your last repetition of steps 3 and 4, apply
sufficient pressure on the chamber gauge ring to make
sure the ring has reached the last stage.
Installing A ControlNet Cable System
This guage moves two rollers toward the
cable and regulates the depth of the cut.
The gauge will "click" as it moves from
one gauge to the next.
Publication 1786-6.2.1 - April 1998
3-11
20073
20074