Installation; Mounting; Mounting Instructions - Faulhaber 22 BX4 SC Series Technical Manual

Installation

4 Installation
 This description must be carefully read and observed before commissioning.
 Observe the environmental conditions (see chap. 2.3, p. 8).
Only trained experts and instructed persons with knowledge of the following fields may
install and commission the motors with integrated Speed Controller:
Automation technology

Standards and regulations (such as the EMC Directive)

 Low Voltage Directive
Machinery Directive

VDE regulations (DIN VDE 0100)

Accident prevention regulations

4.1

Mounting

4.1.1

Mounting instructions

CAUTION!
The motor can become very hot during operation.
 Place a guard against contact and warning notice in the immediate proximity of the
motor.
 Ensure that adequate heat dissipation is provided.
NOTICE!
Installation and connection of the motor when the power supply is applied can damage the
device.
Prior to all aspects of installation and connection work on the motor, switch off the

power supply.
NOTICE!
The motor can be damaged if mounted incorrectly.
 Observe the maximum screw-in depth of the fastening screws (see Tab. 2).
NOTICE!
Excessive loads on the motor shaft can cause irreparable damage to the motor.
 When attaching parts to the motor shaft, observe the maximum permissible load values
(see the product data sheet) of the shaft.
NOTICE!
Excessive radial loads on the servomotor or excessively tightened fastening screws can
cause irreparable damage to the mounting flange.
 Observe the maximum permissible radial load on the motor (see Tab. 2).
 Make sure that the screws are tightened in accordance with Tab. 2.
2nd edition, 31-03-2020 7000.05061, 2nd edition,
14
31-03-20207000.05061