Factory Reset; Backlight - Bush CDAB51R Instruction Manual

FM OPERATION
10 Scan Modes
Auto Scan
The Auto scan setting will scan up or down depending on where the starting
frequency is. Once it finds a station it will stop.
There are 2 options to use when using this function.
NOTE: Ensure you are in the FM mode before following the below steps.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan Setting> option appears, press the ENTER button.
3. You will have the choice of either <Strong Stations Only> or <All Stations>
using the or buttons.
Strong stations only, will only stop at stations with a strong signal. All stations will
stop at any station found with a strong or weak signal.
4. Make your choice by pressing the ENTER button to activate the setting.
Now when you press and hold the BACK/SCAN button the auto scan searches
depending on what setting you chose.
GENERAL OPERATION

Factory Reset

To reset the radio to the factory settings follow the below steps.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan Setting> option appears press either
press the ENTER button.
3. Use the or buttons to find the <Factory Reset> option and press ENTER.
4. Choose <Yes> and press the ENTER button.

Backlight

To set the backlight
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan Setting> option appears press either
<System>, press the ENTER button.
3. Use the or buttons find the <backlight> option and press the ENTER button to
find <Time Out>.
4. Press the ENTER button to enter <time out> and choose the available duration:
<ON>, <10 sec>, <20 sec>, <30 sec>, <45 sec>, <60 sec > , <90 sec>, <120 sec>
and <180 sec>.
10
or and find <System>,
or button and find