Table of Contents
Advertisement
DISASSEMBLY AND REASSEMBLY
FUJICA G$645
5.
Front cover mechanism assembly (5 - 46)
o
Do not loosen eight set screws (5-5) unless otherwise necessary.
These screws
are used to adjust the parallelism between the film plane and shutter installing
surface.
o
When these set screws are loosened, adjust the parallelism in accordance with the
instructions in II - 3 below.
o
Do not remove four washers (6- 22) expect when adjusting focusing performance.
o
When removing the front cover mechanism assembly, remove four set screws
(5. 83).
[REASSEMBLY]
o
Pay attention on the installing directions of the two holders (5- 45).
o
Combine the front cover mechanism assembly with the camera body with the
'
lever (6- 11) released.
o
Open and fold the front cover and make sure that the lever ( 6 - 11) hooks and
unhooks with the leaf spring (5- 16).
-12-
Advertisement
Table of Contents
