Frequently Asked Questions - REVENT RVL50 Installation Manual

Frequently Asked Questions

Q: How do I clean my FAN?
A: It's important to clean the SHIELD cover from time to time. Dust particles can
build up on the SHIELD. See PAGE 19 for care and cleaning instructions.
Q: What is CFM?
A: CFM is a measurement of air movement (cubic feet per minute). The higher the
CFM, the more air movement.
Q: What is a sone?
A: Sone is the rating used to describe the sound level. The lower the sone the
quieter the fan. A sone is not a decibel. Fans around 1 sone or less are considered
quiet while fans around 2 sones or more are considered loud.
Q: Can I install my bathroom ventilation FAN directly over a bathtub or shower?
A: Yes, but your FAN must be rated for over a shower/bath installation (all ReVent
models are) and must be on a GFCI protected circuit. Consult a qualified licensed
electrician about ground fault protected safety circuits.
Q: Do I have to vent my FAN to the outside?
A: Yes. All spot ventilation fans must be vented to the outside. Follow your local
code and consult it for advice. See PAGE 6 for national venting installation
suggestions and guidelines.
Q: Why do the windows and mirrors fog even when the FAN is running?
A: If windows and mirrors are very cold, condensation can still form on those
surfaces. If the bathroom is sealed tightly, replacement air may not be entering the
room fast enough to displace moist air. You need a gap under the bathroom
entrance door to allow air to enter the bathroom. If your home uses 3 inch diameter
ducting, upgrading the duct pipe to 4 inch diameter can greatly increase the airflow.
The vent pipe length should be 10 feet or less with minimal bends (See PAGE 6).
Ensure that the vent pipe is not blocked.
Q: My FAN is operating, but the air is moving slower than normal.
A: Check for obstructions in the ductwork. A common problem is debris blocking the
roof cap or outside wall vent. Older homes may have 3 inch diameter ducting and
changing the duct pipe to 4 inch diameter can greatly increase airflow.
Q: Why is there water dripping from my FAN?
A: Dripping water is typically condensation from a cold vent pipe. Insulating the
ductwork and FAN housing can help solve condensation problems. Running the
FAN longer will ensure moisture is completely removed from the duct. Another
possibility is rain entering the vent pipe through the roof vent opening.
Q: I have installed my FAN and it is not working, what do I do?
A: Make sure the black and white plug-in connector on the FAN is clicked into
place. Check all electrical connections like wire nuts and quick connects. Make
sure the circuit breaker is turned ON after completing all the electrical work. If you
have any concerns consult a licensed electrician.
Q: How do I change the color temperature of the LED light?
A: The color temperature can be adjusted by sliding the selector switch on the back
of the SHIELD (See PAGE 13).
Q: Can the LED light be connected to a dimmer switch?
A: Yes. The LED light can be connected to a dimmer switch, but the dimmer must
be made to work with dimmable LED's. If you are using a dimmer, you cannot
connect the FAN and LED light together on the dimmer switch. The FAN wires
cannot be connected to a dimmer switch.
Q: I only have 1 switch. Can I wire the LED light and FAN together?
A: Yes. See PAGES 10-12 for instructions on how to do this. However, if you are
using a dimmer, you cannot connect the FAN and LED light together on the dimmer
switch. The FAN wires cannot be connected to a dimmer switch.
20