Intertek DONYER POWER CH-1500 Owner's Manual page 6

KEY SLOT MOUNTING INSTALLATION
i WARNING
1. Locate a desired position on your wall in the area to be warmed.
MUST be near an outlet. Unit CANNOT be near electrical cables,
communication lines, pipes, combustible materials, etc. That
could be damaged or ignited by excessive heat.
Using the Mounting Bracket as a template, line up one of the key
2.
slots at each end of the bracket. Mark the 3 slotted openings.
3.
Pre-drill your wall based on the above markings and insert 3 Wall
Anchors.
4. Install 3 x ST4*35 Screws and 1 x Washer provided, leaving about
1/4 inch between the head of the screws and the mounting
surface.
Slip the Mounting Bracket over the screw heads and slide the
bracket to engage the screws in the slots. Tighten the Screws
securely. See Fig. 1
Heater should be at least 3 feet away from combustible material. The
heater is wall mounted only, not suitable for ceiling mounting.
Wall Anchors
Wall
Fig.1
Metal Washer
Key Slots
Mounting Bracket