Radiant construction heaters, indoor use only (10 pages)
Summary of Contents for Intertek DONYER POWER CH-1500
Page 1
DONYER POWER OWNER’S MANUAL WALL MOUNTED GARAGE HEATER MODEL: CH-1500 Read and understand this entire owner’s manual, including all safety information, i WARNING before electric shock, or serious personal injury. CAUTION Keep this owner’s manual for future reference.
This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Thoroughly read the instructions and familiarize yourself with all the operational aspects of your new product. IMPORTANT INSTRUCTIONS When using this electric unit, basic safety precautions should always be followed to reduce the risk of re, electric shock, and injury to persons, including the following: 1.
Page 3
10. DO NOT insert or allow foreign objects to enter any ven- tilation or exhaust opening as this may cause an electric shock or re, or damage the heater. 11. To prevent a possible re, DO NOT block the air intakes or exhaust in any manner.
SPECIFICATIONS VOLTAGE RATING 120 V (60Hz) 12.5 Amps POWER CONSUMPTION 500W 23.6 in W x 3.1 in D x 15.5 in H UNIT SIZE 7.3 lbs UNIT WEIGHT SAFETY FEATURES Overheat Safety Feature This heater is equipped with an overheat safety feature. When the heater’s internal components reach a certain temperature that could cause overheating and possible re, the heater will automatically shut off.
IN THE BOX • Wall Mounted Garage Heater 3 x ST*35 Screws • • • 3 x Wall Anchors 1 x Mounting Bracket 2 x M4* 25 Screws 2 x Nuts • • • 1 x Metal Washer • Owner’s Manual PRODUCT DIAGRAM LED Light Mounting Bracket...
Page 6
KEY SLOT MOUNTING INSTALLATION Heater should be at least 3 feet away from combustible material. The i WARNING heater is wall mounted only, not suitable for ceiling mounting. 1. Locate a desired position on your wall in the area to be warmed. MUST be near an outlet.
Page 7
ATTACHING HEATER TO MOUNTING BRACKET Always remove the Screw from each Rotating Arm before attaching heater to Mounting Bracket. Do not forget to put the Screws back in i WARNING each Rotating Arm after attaching the heater. Otherwise, the heater could slide out of Mounting Bracket and cause injury or damage.
Page 8
REMOVING HEATER FROM MOUNTING BRACKET Unplug the unit and let it cool completely. Remove Screws from each Rotating Arm. Push-in the two arm release button on the side of each arm. Grasp both arms and simultaneously pull the unit down while holding the buttons in.
MAINTENANCE 1. Set the power to OFF Position. 2. Unplug the unit and let it cool completely. 3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. A mild detergent can be used if necessary.
TROUBLESHOOTING If the heater will not operate, please check the following: 1. Check if the power cord is plugged into an electrical outlet. If not, plug in unit to appropriate outlet. 2. Check if electricity to the outlet is working 3.
Need help?
Do you have a question about the DONYER POWER CH-1500 and is the answer not in the manual?
Questions and answers