Fuel Tank Filter; Fuel Filter - Echo BEAR CAT EGI-2000 Operation Manual

1. Remove the screws
r Owner's Manual
pull outward on the areas of the
cover
②
2. Loosen the bolt
TIP: Align the spark arrester projection (7) with
remove the muffler cap
the hole (8) in the muffler pipe.
muffler screen
rews and then
①
arrester
⑥
，
6. Install the muffler screen and the muffler cap.
n the areas of the
3. Clean the carbon on the muffler
7. Install the cover and tighten the screws.
wn.
screen by wire brush.
t and then
③
ffler cap , the
④
NOTICE

7.6 Fuel tank filter

and spark
⑤
on on the muffler
brush.
• Never use the gasoline while smoking or in the
vicinity of an open flame.
en cleaning, use the
4. Check the muffler screen and
brush lightly to
spark arrester, replace if it
d damaging or
1. Remove the fuel tank cap and filter.
damage.
nce
tching the muffler
2. Clean the filter with gasoline.
5. Install spark arrester.
nual
en and spark
3. Wipe the filter and install it.
ster.
!
WARNING
4. Install the fuel tank cap.
CARBURETOR ADJUSTMENT
fler screen and
The carburetor is a vital part of the engine. Adjusting should be left to a
ine
dealer with the professional knowledge, specialized date, and equipment to
replace if it
Be sure the fuel tank cap is tightened securely.
do so properly.
k
ENGINE OIL REPLACEMENT
rester.
side

7.7 Fuel filter

ing in areas prone
TIP:
he
res such as forest
Align the spark arrester
1. Remove the screws (1), and then remove the cover (2), and drain
oods, never use
he
projection
the fuel (3).
ngine without an
the muffler pipe.
ropriate spark
6. Install the muffler screen and the
d
ster.
muffler cap.
7. Install the cover and tighten the
d gap. rk arrester
screws.
with the hole in
⑧
pe.
N) fler screen and the
2. Hold and move up the clamp (4), then take off the hose (5)
from the tank.
er and tighten the
3. Take out the fuel filter (6).
4. Clean the filter with gasoline.
8in)
5. Dry the filter and put it back into tank.
6. Install the hose and clamp, then open the fuel valve to check for leaks.
7. Install the cover and tighten the screws.
te of
2
ever,
e.
maIntEnancE
and then
①
，
shown.
and then FUEL TANK FILTER
③
, the
④
and spark
⑤
.
When cleaning, use the
wire brush lightly to
avoid damaging or
scratching the muffler
WARNING
screen and spark
arrester.
If using in areas prone
to fires such as forest
or woods, never use
FUEL FILTER
an engine without an
appropriate spark
arrester.
with the hole
⑦ ⑧
FUEL TANK FILTER
FUEL FILTER
Maintenance
Inverter Generator Owner's Manual
Avoid draining the
! WARNING
engine oil immediately
in
after stopping the
engine. The oil is hot
and should be handled
with care to avoid
burns .
1. Place the generator on a level
surface and warm up the engine
for several minutes. Stop the
engine and turn the 3 in 1 switch
knob and fuel tank cap air vent
knob to "OFF".
2. Remove the screw
remove the cover
3. Remove the oil filler cap
4. Place an oil pan under the engine.
Tilt the generator to drain the oil
completely.
5. Replace the generator to a level
surface.
Do not tilt the generator
NOTICE
when adding engine oil.
This could result in
overfilling and damage
to the engine.
Inverter Generator Owner's
! WARNING
1. Remove the fuel tank cap
and filter.
2. Clean the filter with gaso
3. Wipe the filter and install
4. Install the fuel tank cap.
Be sure the fuel tank cap
tightened securely.
1. Remove the screws
remove the cover
fuel
2. Hold and move up the cla
then take off the hose
the tank.
3. Take out the fuel filter
4. Clean the filter with gaso
5. Dry the filter and replace
6. Install the hose and clam
open the fuel valve to che
and then
①
leaks.
.
②
7. Install the cover and tight
③
.
screws.
29
Mainten
! WAR
1. Re
Never use gaso
2. Cl
while smoking o
3. W
vicinity of an op
flame. 4. In
Be s
tight
1. Re
2. Ho
, a
①
3. Ta
dra
② 4. Cl
，
.
③ 5. Dr
6. In
⑤
⑥
7. In
31
an
re
fu
th
th
op
le
.
sc