Overload Indicator Light (Red); Ac Pilot Light (Green) - Echo BEAR CAT EGI-2000 Operation Manual

OVERLOAD INDICATOR LIGHT (RED)

12

AC PILOT LIGHT (GREEN)

12
electrical device is detected, the
inverter control unit overheats, or the
AC output voltage rises. Then, the AC
control functIon
protector will trip, stopping power
generation in order to protect the
generator and any connected electric
devices. The AC pilot light (Green)
will go off and the overload indicator
light (Red) will stay on, but the engine
will not stop running.
The overload indicator light comes on when
an overload of a connected electrical device
When the overload indicator light
is detected, the inverter control unit overheats,
comes on and power generation
or the AC output voltage rises. Then, the AC
stops, proceed as follows:
1. Turn off any connected electric
protector will trip, stopping power generation
devices and stop the engine.
in order to protect the generator and any
2. Reduce the total wattage of
connected electric devices. The AC pilot light
connected electric devices within the
(Green) will go off and the overload indicator
rated output.
light (Red) will stay on, but the engine will not
3. Check for blockages in the cooling
stop running. When the overload indicator
air Inlet and around the control unit. If
light comes on and power generation stops,
any blockages are found remove.
proceed as follows:
4. After checking, restart the engine.
1. Turn off any connected electric devices
TIP：The overload indicator light may
and stop the engine.
come on for a few seconds at first
2. Reduce the total wattage of connected
when using electric devices that
electric devices within the rated output.
require a large starting current,
3. Check for blockages in the cooling air
such as a compressor or a
Inlet and around the control unit. If any submergible pump. However, this
is not a malfunction.
blockages are found remove.
4. After checking, restart the engine.
TIP: The overload indicator light may come on
for a few seconds at first when using electric
devices that require a large starting current,
Control Function
such as a compressor or a submergible pump.
Inverter Generator Owner's Manual
However, this is not a malfunction.
AC pilot light (Green)
The AC pilot light comes on when the engine
starts and produces power.
The AC pilot light
①
engine starts and produces power.
DC protector
The DC protector turns to "OFF"
automatically when electric device being
connected to the generator is operating
and current above the rated flows. To use
this equipment again, turn on DC
protector by pressing its button to "ON"
comes on when the
.
①