Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Echo BEAR CAT EGI-2000
Summary of Contents for Echo BEAR CAT EGI-2000
- Page 1 EGI-2000 INVERTER GENERATOR operation manual...
- Page 2 tablE of contEnts Safety Introduction Safety Warnings Safety Information Description 10 Description 11 Control Panel Control Function 12 3 in 1 switch knob 12 Oil warning light (red) 13 Overload indicator light (red) 13 AC pilot light (green) 14 DC protector 14 Engine smart control (ESC) 15 Fuel tank cap 15 Fuel tank cap air vent knob...
- Page 3 tablE of contEnts Maintenance 25 Maintenance 27 Spark plug inspection 28 Carburetor adjustment 28 Engine oil replacement 29 Air filter 30 Muffler screen and spark Arrester 31 Fuel tank filter 31 Fuel filter Storage 32 Drain the fuel 32 Engine Troubleshooting 32 Engine won’t start 34 Generator won’t produce power...
- Page 4 This manual contains information for the complete range of ECHO generators, and was written to take you from the safety requirements to the operating functions of your machine. You can refer back to the manual at any time to help troubleshoot any specific operating functions, so store it with the machine at all times.
- Page 5 safEty Save these Instructions Safety Warnings This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. The safety alert symbol ( ) is used with a signal word (DANGER, CAUTION, WARNING), a pictorial and/or a safety message to alert you to hazards.
- Page 6 safEty 1. SAFETY INFORMATION Read and understand this owner’s manual before operating your generator. It will help you avoid accidents if you get familiar with your generator’s safe operation procedures. WARNING • Do not use it indoors. • Keep the machine clean and avoid spilt combustibles including gasoline on it.
- Page 7 safEty CONNECTION TO A HOME POWER SUPPLY If the generator is to be used as standby home power supply the connection is to be performed by a qualified electrician. When loads are connected to the generator, carefully check whether electrical Safety Information connections are safe and reliable.
- Page 8 safEty UNIT SAFETY SYMBOLS There is the warning label on the machine to remind you of the safety regulations. SYMBOLS Read the safety instructions before using the generator. Only fill the generator in well-ventilated areas and keep it away from open flames sparks and cigarettes Spilled fuel should be soaked up immediately.
- Page 9 control functIon Control Function Control Function Inverter Generator Owner's Manual Inverter Generator Owner's Manual Control Function Control Function DESCRIPTION Control Function DESCRIPTION DESCRIPTION Handle Handle Fuel tank cap air Fuel tank cap air vent knob vent knob ( ) Fuel tank cap ( ) Fuel tank cap ( ) Control panel ( ) Control panel...
- Page 10 dEscrIptIon Control Function Control Function Inverter Generator Owner's Manual Inverter Generator Owner's Manual CONT 230V 50HZ 230V 50Hz CONT 230V 50Hz Oil warning light Oil warning light Overload indicator light Overload indicator light ( ) AC pilot light ( ) AC pilot light ( ) ESC(engine smart control) ( ) ESC(engine smart control) ( ) 3 in 1 switch knob...
- Page 11 Control Function CONTROL FUNCTION Inverter Generator Owner's Manual 3 in 1 switch knob dEscrIptIon CONTROL FUNCTION Engine/fuel valve OFF”;Ignition “ 3 in 1 switch knob circuit is switched off. Fuel is switched off. The engine will not run. Engine switch \fuel valve \chock. Engine/fuel valve OFF”;Ignition “...
- Page 12 electrical device is detected, the inverter control unit overheats, or the AC output voltage rises. Then, the AC control functIon protector will trip, stopping power generation in order to protect the generator and any connected electric devices. The AC pilot light (Green) will go off and the overload indicator OVERLOAD INDICATOR LIGHT (RED) light (Red) will stay on, but the engine...
- Page 13 DC protector control functIon The DC protector turns to “OFF” automatically when electric device being connected to the generator is operating DC PROTECTOR and current above the rated flows. To use this equipment again, turn on DC The DC protector turns to “OFF” automatically protector by pressing its button to “ON”...
- Page 14 control functIon Control Function Control Function Inverter Generator Owner's Manual Inverter Generator Owner's Manual Fuel tank cap FUEL TANK CAP Fuel tank cap 1. Remove the fuel tank cap by turning 1. Remove the fuel tank cap by turning it 1.
- Page 15 opEratIon Pre-Operation NOTICE Pre-oparation • Pre-operation checks should be made each time operation. Inverter Generator Owner's Manual Pre-oparation WARNING • The engine and muffler will be very hot after the engine has been run. Pre-operation checks should be made each time NOTICE Engine Oi Avoid touching the engine and muffler while they are still hot with any...
- Page 16 opEratIon Pre-oparation Pre-oparation Inverter Generator Owner's Manual Inverter Generator Owner's Manual ENGINE OIL Engine Oil The generator has been shipped without engine oil. Do not start the Engine Oil engine until full with the sufficient engine oil. The generator has been shipped without engine oil. Do not start the engine till fill with the sufficient engine oil.
- Page 17 opEratIon Operation Operation Inverter Generator Owner's Manual Inverter Generator Owner's Manual Operation Operation Operation Never operate the engine in a closed area or it may cause NOTICE unconsciousness and death within a short time. Operate Never operate the engine in a closed area or it may cause TIP: NOTICE the engine in a well ventilated area.
- Page 18 recoil starter. After the engine starts, warm up prEparatIon the engine until the engine does not stop when the choke knob is returned to the “ON” position TIP: When starting the engine, After the engine starts, warm up the engine with the ESC “ON”...
- Page 19 opEratIon ALTERNATING CURRENT (AC) CONNECTION WARNING • Be sure any electric devices are turned off before plugging them in. NOTICE • Be sure all electric devices including the lines and plug connections are in good condition before connection to the generator. •...
- Page 20 opEratIon BATTERY CHARGING TIP: • The generator DC rated voltage is 12V. • Start the engine first, and then connect the generator to the battery for charging. • Before starting to charge the battery, make sure that the DC protector is turned on.
- Page 21 opEratIon WARNING • Never smoke or use broken connectors on the battery while charging. Sparks may ignite the battery gas. • Battery electrolyte is poisonous and dangerous, causing severe burns, etc. contains sulfuric (sulphuric) acid. Avoid contact with skin, eyes or clothing. •...
- Page 22 opEratIon AC PARALLEL OPERATION APPLICATIONS TIP: • Make sure that it is in good working order. A faulty appliance or power cord can create a potential for electrical shock. • If an appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn it off immediately.
- Page 23 opEratIon Application range When using the generator, make sure the total load is within rated output of a generator. Otherwise, generator damage may occur. Power 0.8-0.95 0.4-0.75 Factor (Efficiency 0.85) Rated 1,600W 1,280W 544W Rated output voltage 12V power TIP: •...
- Page 24 opEratIon NOTICE • Do not overload. The total load of all electrical appliances must not exceed the supply range of the generator. Overloading will damage the generator. • When supplying precision equipment, electronic controllers, PCs, Electronic computers, microcomputer based equipment or battery chargers, keep the generator a sufficient distance away to prevent electrical interference from the engine.
- Page 25 maIntEnancE Maintenance Safety is an obligation of the owner. Periodic inspection, adjustment and lubrication will keep your generator in the safest and most efficient condition possible. The most important points of generator inspection and lubrication are explained on the following pages. WARNING •...
- Page 26 maIntEnancE Item Routine Pre-operation 6 Months / 12 Months / check (daily) 100 Hours 300 Hours Clean and replace Fuel Filter us necessary. Check hose weather Crankcase for cracks or breather hose damage. Replace if necessary. Decarbonizes cylinder head. Cylinder head More frequently if necessary.
- Page 27 maIntEnancE Maintenance Inverter Generator Owner's Manual CARBURETOR SPARK PLUG INSPECTION The carburetor i The spark plug is important engine SPARK PLUG INSPECTION dealer with the p components, which should be checked periodically. do so properly. The spark plug is important engine 1.
- Page 28 maIntEnancE 7.2 Carburetor adjustment The carburetor is a vital part of the engine. Adjusting should be left to our company authorized dealer with the professional knowledge, specialized date, and equipment to do so properly. 7.3 Engine oil replacement WARNING Maintenance Inverter Generator Owner's Manual nual •...
- Page 29 maIntEnancE 6. Add engine oil to the upper level. Recommended engine oil: SAE SJ 10W-30 Recommended engine oil grade: API Service SE type or higher Engine oil quantity: 0.35L / 0.37 qt 7. Wipe the cover clean, and wipe up any spilled oil. NOTICE Maintenance Inverter Generator Owner's Manual...
- Page 30 maIntEnancE The engine should never run without the foam element; excessive piston and cylinder wear may result. 7. Install the air filter case cover in its original position and tighten Inverter Gener the screw. 8. Install the cover and tighten the screws. 7.5 Muffler screen and spark arrester Maintenance 1.
- Page 31 FUEL TANK FILTER maIntEnancE Maintenance Mainten 1. Remove the screws and then ① ， r Owner's Manual Inverter Generator Owner's pull outward on the areas of the cover shown. ② 2. Loosen the bolt and then FUEL TANK FILTER ③ TIP: Align the spark arrester projection (7) with remove the muffler cap , the...
- Page 32 Long term storage of your machine will require some preventive procedures to guard against deterioration. Storage DRAIN THE FUEL storaGE Inverter Generator Owner's Manual 1. Turn the 3 in 1 switch to “OFF” . ① Storage 2. Remove the fuel tank cap, remove the filter.
- Page 33 troublEshootInG 8.2 Engine Perform the following steps to protect the cylinder, piston ring, etc. from corrosion. 1. Remove the spark plug, pour about one tablespoon of SAE 10W-30 into the spark plug hole and reinstall the spark plug. Recoil start the engine by turning over several times (with 3 in 1 switch knob off) to coat the cylinder walls with oil.
- Page 34 spEcIfIcatIons 9.2 Generator won’t produce power · Safety device (DC protector) to “OFF”…. Press the DC protector to “ON”. · The AC pilot light (Green) goes off …. Stop the engine, then restart. 10. SPECIFICATIONS Item EGI-2000 Generator Type Silent Inverter Rated frequency (Hz) * 50/60/50 Rated voltage (V) *...
- Page 35 wIrInG dIaGram 11. WIRING DIAGRAM • 60Hz, 120V Without Parallel Receptacle...
- Page 36 wIrInG dIaGram Electrical Schematic Diagram Inverter Generator Owner's Manual • 60Hz, 120V With Parallel Receptacle 60Hz, 120V With Parallel Receptacle...
- Page 37 wIrInG dIaGram Electrical Schematic Diagram Inverter Generator Owner's Manual • 50Hz, 230V Without Parallel Receptacle 50Hz, 230V Without Parallel Receptacle...
- Page 38 wIrInG dIaGram Electrical Schematic Diagram Inverter Generator Owner's Manual • 50Hz, 230V With Parallel Receptacle 50Hz, 230V With Parallel Receptacle...
- Page 39 wIrInG dIaGram Electrical Schematic Diagram Inverter Generator Owner's Manual • 50Hz / 60Hz, 100V With Parallel Receptacle 50Hz / 60Hz, 100V With Parallel Receptacle...
- Page 40 wIrInG dIaGram Electrical Schematic Diagram Inverter Generator Owner's Manual • 50Hz, 110V With Parallel Receptacle 50Hz, 110V With Parallel Receptacle...
- Page 41 1.888.625.4520 service@bearcatproducts.com...