Air Filter - Echo BEAR CAT EGI-2000 Operation Manual

6. Add engine oil to the upper level.
Recommended engine oil: SAE SJ 10W-30
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: 0.35L / 0.37 qt
7. Wipe the cover clean, and wipe up any spilled oil.
e
al
• Be sure no foreign material enters the crankcase.
CARBURETOR ADJUSTMENT
The carburetor is a vital part of the engine. Adjusting should be left to a
8. Install the oil filler cap.
dealer with the professional knowledge, specialized date, and equipment to
9. Install the cover and tighten the screws.
do so properly.
ENGINE OIL REPLACEMENT
e

7.4 Air filter

1. Remove the screws (1), and then remove the cover (2).
2. Remove the screw (3) and then remove the air filter case cover (4).
gap.
3. Remove the foam element (5).
4. Wash the foam element in solvent and dry it.
5. Oil the foam element and squeeze out excess oil.
The foam element should be wet but not dripping.
• Do not wring out the foam element when
squeezing it. This could cause it to tear.
of
er,
AIR FILTER
6. Insert the foam element into the air filter case.
TIP: Be sure the foam element seals properly
against the air filter holder to avoid air leakage.
maIntEnancE
NOTICE
Maintenance
Inverter Generator Owner's Manual
Avoid draining the
! WARNING
engine oil immediately
after stopping the
engine. The oil is hot
and should be handled
with care to avoid
burns .
1. Place the generator on a level
surface and warm up the engine
Maintenance
for several minutes. Stop the
engine and turn the 3 in 1 switch
Inverter Generator Owner's Manual
knob and fuel tank cap air vent
knob to "OFF".
2. Remove the screw 6. Add engine oil to the upper level.
remove the cover
Recommended engine oil:
SAE 10W -30
3. Remove the oil filler cap
Recommended engine oil grade:
4. Place an oil pan under the engine.
API Service SE type or higher
Tilt the generator to drain the oil
Engine oil quantity:
0.35 L (0.42 US qt, 0.35 lmp qt)
completely.
5. Replace the generator to a level
7. Wipe the cover clean, and wipe up
surface.
any spilled oil.
NOTICE
Be sure no foreign
NOTICE
Do not tilt the generator
material enters the
NOTICE
crankcase.
when adding engine oil.
This could result in
8. Install the oil filler cap.
9. Install the cover and tighten the overfilling and damage
screws.
to the engine.
1. Remove the screw
remove the cover
②
2. Remove the screw
remove the air filter case
cover .
④
and then
①
.
②
③
.
29
and then
①
.
and then
③
MUFFLER SCREEN
! WARNING
Inverter Gene
3. Remove
4. Wash th
and dry
5. Oil the fo
out exce
should b
NOTICE
6. Insert th
air filter
TIP:
Be sure
properl
holder t
The en
withou
excess
wear m
7. Install th
its origin
the screw
8. Install th
screws
The engine and muffler will be ve
has been run. Avoid touching the
while they are still hot with any p
clothing during inspection or repa
29