Table of Contents
Advertisement
C
ONNECTING THE
38
A
PPLIANCE TO THE
The procedure to connect each appliance to the network is the same. The only
difference for connection is type of appliance you have.
To connect your appliance to the network, complete the following steps:
1.
Select your appliance from the types of servers shown below.
2.
Follow the procedure for connecting the appliance to the network in the section,
"Connecting to the Network" on page
Types of Servers
This section illustrates the types of StealthWatch appliances used in a network.
SMCs 1000 & 2000 and FlowCollectors 1000 & 2000
This appliance is used for the SMCs 500/1000, 1000 and 2000, the FlowCollectors
1000 and 2000, and the FlowSensors 2000 and 3000.
Height: 1.68 inches (4.3 cm)
Width: 18.99 inches (48.24 cm) with rack latches
17.08 (43.4 cm) without rack latches
Depth: 27.8 inches (70.67 cm) with power supplies and bezel
28.6 inches (72.53 cm) without power supplies and bezel
Heat Dissipation: 2,891 BTUs per hour maximum
Power: Redundant, hot swappable: 750W, 50/60 Hz; Auto Ranging
(100V to 240V)
43.
Installation
N
ETWORK
Advertisement
Table of Contents
