Table of Contents
Advertisement
M
OUNTING THE
24
A
PPLIANCE
You can mount StealthWatch products directly in a standard 19'' rack or cabinet. You
can also install them in any other suitable cabinet or on a flat surface.
Note:
When mounting an appliance in a rack or cabinet, follow the instructions included
in the rail mounting kits.
When determining where to place an appliance, make sure that clearance to the front
and rear panels is as follows:
The front-panel indicators can be read easily.
Access to ports on rear panel is sufficient for unrestricted cabling.
The rear-panel power inlet is within reach of a conditioned AC power
source.
Airflow around the appliance and through the vents is unrestricted.
Hardware Included with the Appliance
The following hardware is included with StealthWatch System products:
AC power cord
Access keys (for front face plate)
Rail kit for rack mounting, or mounting ears for smaller appliances
For the FlowCollector 5000, a 10G SFP cable
Additional Required Hardware
You must provide the following additional required hardware:
Mounting screws for a standard 19" rack
Uninterruptible power supply (UPS) for each StealthWatch System product
you are installing.
Ethernet cables as shown in the following table, based on the product you
are installing and the configuration you ordered. You can use the Total
columns as a checklist to help you plan for the quantity you need.
Management
Product
Port
FC 1000
1 Copper
Monitoring
Port(s)
1 Copper
Installation
Total
Total
Copper
Fiber-Optic
Advertisement
Table of Contents
