Chapter 2. External Indicators, Controls, And Connectors; Management-Module Indicators And Controls - IBM BladeCenter Advanced Management Module Installation Manual

Chapter 2. External indicators, controls, and connectors

This chapter describes the indicators, controls, and external connectors on the
management module.

Management-module indicators and controls

Power-on LED
Active LED
Management module
error LED
OK
Ethernet link LED
LINK
TX/RX
Ethernet activity LED
Reset
The following management-module LEDs provide status information about the
management module and remote-management connection.
v Power-on LED: When this green LED is lit, it indicates that the management
module has power.
v Active LED: When this green LED is lit, it indicates that the management
module is actively controlling the BladeCenter unit. Only one management
module actively controls the BladeCenter unit. If two management modules
are installed in the BladeCenter unit, this LED is lit on only one module.
v Management module error LED: When this amber LED is lit, it indicates
that an error has been detected in the management module. When this LED
is lit, the BladeCenter unit system error LED is also lit.
© Copyright IBM Corp. 2008
7