Burner flames lift
off ports, are
Contact an authorized Roper service
technician to check air/gas mixture.
Burner is wet from washing.
will not turn
cycle will not
You are not pushing in before
The Oven Selector and Oven
Control are not set
The range clock does not show
the correct time of day.
The Lock Lever is not in the
the way to
The Start Time Dial does not
show the correct time of day or
the knob is not all the way out.
The Stop Time Dial is not set
ahead to the time you want the
cleaning cycle to stop.
Push control knob(s) in before turning to a
Set both the Oven Selector and Oven
Control to CLEAN.
Reset clock to show the correct
day. (See page
Move Lock Lever all the way to the right.
Reset the Start Time Knob to show the
correct time of day. Pull knob out all the
See Step 3 in "Setting the controls" on
for proper setting instructions.
The range is not level.
Level range. (See Installation Instruc-
are not what you
The oven temperature
Adjust the oven temperature
low or too high.
"Adjusting the oven temperature
on page 13.)
The oven was not preheated as
Preheat oven if called for in recipe.
the recipe calls for.
The recipe has never been
Use only tested recipes from a reliable
tested or is not from a reliable
The pans are not the type or size
Refer to a reliable cookbook for recom-
in the recipe.
mended pan type and size.
There is not proper air circulation
Allow 1% to 2 inches (4-5 cm) on
around pan when baking.
of the pans for air circulation.
be a minimum space of 1 inch (2.5 cm).
Flame size does not fit the
Adjust flame size to fit cooking utensil.
cooking utensil being used.
When broiling, you have not
close oven door.
closed the oven door.