Eaton Memshield 3 Series Instruction Leaflet

LH OUTGOING CIRCUITS RH OUTGOING CIRCUITS
FED FROM:
INCOMING CABLE SIZE:
INSTALLATION DATE:
CONTRACTOR:
Warning - The use to which this product is put and its place of installation is outside our control.
Intellectual Property Rights
Particular care should therefore be taken to follow the instructions given here and to
Eaton wishes to make it clear that it
ensure their continued availability in conjunction with the use of the product.
owns intellectual property rights in the
No responsibility can be accepted by us if these instructions are disregarded. Further
product which it manufactures (whether
or not listed in this leaflet) and that it will
copies of these instructions and information concerning the installation and proper use
take legal action against any party
of this product can be obtained by contacting the:
found to be manufacturing, using, or
Technical Services Department
selling any article which infringes the
Eaton Electric Limited,
company's intellectual property. All
marks in this document identified with Middleton,
an R symbol or a TM symbol adjacent
Manchester, M24 1GQ.
to the mark are trademarks of Eaton.
Tel: +44(0)8700 545 333,
© 2019 Eaton Electric Limited,
email: ukcommorders@eaton.com
www.eaton.com/recycling
All rights reserved.
LABEL FITTING
Ensure all way labels are fitted in the correct places
BOTTOM FEED
L1
Busbar
Way
Label
Cover Way
Labels
Earth
Labels
L1
Phase Label
TOP FEED
Earth
Labels
Cover Way
Labels
L1
Memshield 3 630/800A Panelboard/Pan Assemblies
EPBN2863, EPBN21263, EPBN21863, EPBN3880, EPBN31240
EPBPN2863, EPBPN21263, EPBPN21863, EPBPN3880, EPBPN31240
Main Switch
Label Instruction leaflet LT1210 (12/19)
IMPORTANT NOTES
1. This product should be installed, commissioned and maintained by or under the supervision of a competent electrician
in accordance with current electrical engineering Codes of Practice, Regulations for the Electrical equipment of
Buildings (BS7671), CDM2007 - Construction (Design and Management) Regulations 2007, HSG150 - Health and
Safety in Construction, Statutory requirements and any Specific instruction issued by the Company.
2. After completing the installation and testing of this product it is essential that this leaflet is drawn to the attention of
the person responsible for its future operation and maintenance, and is at all times available for ready reference.
3. These notes assume throughout that the product is disconnected from the supply. It is essential that this is done
before any work is carried out.
4. These Panelboards are only designed for use with Eaton MCCBs. Failure to comply will result in invalid warranty and certification.
5. Operation of the incoming and outgoing devices should only be carried out by an instructed or skilled person.
630A MCCB INCOMER FITTING
EPBKN2633
Main Switch
Label
Position
on Cover
630A DIRECT CABLE
INCOMER FITTING EPBKN263L
(FOR 630A PANELBOARDS ONLY)
800A MCCB INCOMER FITTING
EPBKN2634 EPBKN3803
14Nm
31Nm
Position
on Cover
NOTE: When Top Fed, MCCB terminations must be reversed
14Nm
EPBKN3804
14Nm
31Nm
31Nm
46Nm
MCCB INCOMING COVER
KNOCKOUT REMOVAL
Remove for 3 Pole
Remove for 4 Pole Top and Bottom
Feed Incomer
Bottom Feed Incomer
Remove for
4 Pole Top
Feed Incomer
DO NOT REMOVE FOR DIRECT
CABLE INCOMER