Setting The Cooking Mode And Temperature; Operation - Oven; About The Oven; Operation - Bosch Electric Range with Magnetic Control Knob and European Convection Use And Care Manual

Changing the Element Heat Level
Turning Off the Element
Operation without the
Magnetic Dial
Setting the Element Heat Level
Selecting the Number of Element
Rings
Turning Off the Element

Operation - Oven

About the Oven

Operation

Setting the Cooking
Mode
and Temperature
English 16
1. Press element touchpad.
2. Turn dial to desired heat level. When the number stops flashing, the element
is set.
1. Press element touchpad twice.
1. Remove magnetic dial from touchpad. After 15 seconds, the panel lock acti-
vates.
2. Unlock the panel. Press and hold the Panel Lock touchpad for five seconds or
until the control beeps.
3. Press element pad for desired element. Display shows 0.
4. Press element pad repeatedly until desired heat setting is displayed. When
the number stops flashing, the element is set.
1. Set the element heat level. The element defaults to the highest number of
rings available.
2. Press element touchpad.
3. Press the pot sizing touch pad.
4. Continue to press pot sizing touchpad until desired number of rings is
selected.
Note: = two rings;
1. Press element touchpad twice.
This section explains how to operate the oven. See "Getting the Most Out of Your
Oven" on page 23 for guidelines to improve oven results.
CAUTION
Do not use aluminum foil or protective liners to line any part of an appli-
ance, especially surface unit drip bowls or oven bottom. Installation of
these liners may result in a risk of electric shock or fire.
Note: To back out of a current mode, press OFF. (Selecting OFF when not setting
the cooking mode will turn the oven off.)
1. Press COOKING MODE.
2. BAKE will flash in the display.
3. If no change is made within 5 seconds,
control will beep and flash. If this occurs,
press START.
4. To change the cooking mode, turn knob.
= three rings.
6: 35
380
PM
100 BAKE