Gap Between Dot Head And Platen; Power Cord Connection - C.ITOH 8510A User Manual

6. Gap between Dot Head and Platen
The gap between the head needle end and the platen is adjustable in 4 steps.
(a) When the gap adjusting lever is pushed fully away from you, the gap between the head needle
end and the platen will be 0.5 to 0.55. The lever is usually set at this position when a single
sheet of paper is used.
(b) Depending on the number of sheets of paper, pull the gap adjusting lever toward you to adjust
the gap.
Head
Platen·to-head gap with
adjusting lever fully
pushed away from you.
Head Adjusting Lever
Fig. 13 Gap Adjustment between Dot Head and Platen
7. Power Cord Connection
..
~-""7"C--
Gap of 0.8 to 0.85
Gap of 0.7 to 0.75
Gap of 0.6 to 0.65
Gap of 0.5 to 0.55
(Single paper)
Connect the attached power cord to the printer, and insert the plug into the AC outlet.
-11-