Table of Contents
Advertisement
7-4. LF or NON-LF when DATA BUFFER is Full
When the DATA BUFFER is full, the data will be printed out without a print command code. At this
point, one line feed mayor may not take place, depending on the position of the DIP switch.
Condition
SWI-6
LF
Closed
Non-LF
Open
(ST)
7-5.
Print Command Code
Several command codes in addition to CR may serve as print command codes. (In incremental print
mode this selection is unnecessary because each character is printed as it is received.)
Command Code
SWI-7
CR Only
Open
CR, LF, VT, FF, US
Closed
i'--
7-6. Function of CR
One line feed mayor may not take place following a Carriage Return.
Function
SWI-S
CR
Open
(ST)
CR+LF
Closed
7-7. Numeric Display of 0
The numeral 0 may be printed with or without a slash.
Display
SW2-1
0
Open
(ST)
0
Closed
7-S. Selection of Character Pitch at Power-On
Characters may be printed 10 CPI or proportionally (spacing allowance made depending on the size of
the character).
These are the options available at Power-On. Other print modes are software selectable. See section
14-2 for details.
Print Mode
SW2-5
10 CPI character
Open
(ST)
Proportional character
Closed
-18-
Advertisement
Table of Contents
