CODES
FF (OC)H
Form Feed
12 Decimal
CAN (18)H
Cancel
24 Decimal
SO (OE)H
Shift Out
14 Decimal
SI (OF)H
Shift In
DCI (11)H
Device Control 1
DC3 (13)H
Device Control 3
BS (08)H
Back Space
HT (09)H
Horizontal Tab
DC2 (l2)H
Device Cont. 2
FUNCTION
• Multiple line feed code, automatic feed to top of form (TOF)
position, as set in VFU channell. (The form does not stop at the
BOF position set in VFU.)
• Can be selected as a print command in logic seek print mode by
setting DIP SW (SWl-7) closed when SW-7 is open, FF after print
data is ignored.
• The above also applies to REVERSE mode.
• Cancels print data received prior to this code and within the same
line as this code.
• This code is ignored in incremental print mode.
• Any control code or print mode in effect prior to the CAN code
remains valid. The last mode before the reception of CAN code
is maintained.
• Elongated character command code. (Double Width Character)
• Data following reception of this code shall be elongated until
SI code is received.
• This code functions as a selection code for selecting KANA
character area in case Japanese 7-bit code is used (SWl-l - 1-3/
OPEN, SW2-6/CLOSED).
• A clear command for elongated character command.
• In case the Japanese 7-bit code is used, this code functions as a
clearing code for KANA character area and selects Alpha-Numeric
area.
• This code is used to place printer in SELECT state.
• Can be ineffective by setting switch (SWI-5) closed.
• Code is used to place printer in DESELECT state.
• Can be ineffective by setting DIP switch (SWI-5) CLOSED.
• Effective only in incremental print mode.
• Back space command. Back spacing is carried out after the data
received just prior to this code is printed.
• Ignored when no print data is found.
• The printer head will not stop at the next position to be printed.
• Moves the print position to the nearest horizontal tab set position.
Ignored when no horizontal tab set is found.
• Not ignored in incremental print mode. The carrier slides to the
right end.
• Elongated character command code in case Japanese 7-bit code is
used.
• Japanese 7-bit code data following this code shall be elongated
until DC 4 code is received.
• Ignored when codes other than Japanese 7-bit code are used.
-42-