National Instruments GPIB-SCSI-A Getting Started page 17

1
1 To GPIB Devices
2 Terminating Resistors
© National Instruments Corporation
Figure 2-4 shows where to install terminating resistors if the GPIB-SCSI-A
is located at the end of a system.
2
A
S I- R
L L E
S C R O
IB -
N T
G P C O
S I
S C
8 8
E -4
IE E
IV E
C E
R E
N D
S E
N
T E
L IS
L K
T A
A D Y
R E
3
R
W E
P O
3 GPIB-SCSI-A
4 SCSI Tape Drive
Figure 2-4. Location of Terminating Resistors for GPIB-SCSI-A at End of SCSI Bus
If your GPIB-SCSI-A is not located at the end of the SCSI bus, remove
the terminating resistor pack from the rear panel of the GPIB-SCSI-A. Also
ensure that all other devices in the middle of the bus (for example, the SCSI
disk drive in Figure 2-5) do not have terminating resistors installed. The
devices at each end of the SCSI bus should have terminating resistors
installed.
4
5 SCSI Disk Drive
6 SCSI Host
2-7
Chapter 2 Installation
5
GPIB-SCSI-A for Solaris
6