Advertisement
Quick Links
The XCEED truck bed cover requires the
installation of rails and some small parts.
Note any damaged or missing
components before installing.
Tools required:
9/16" and 1/2" sockets and ratchet wrench,
Phillips screwdriver
It is important that
all areas where the
bed cover mounts
a bed liner, install the
are clean and free
cab/bulkhead seal.
of debris prior to
Wipe the painted
installing.
surfaces with
isopropyl alcohol
before applying.
Make sure the rail is clamped square with the truck bed rail
and bulkhead. Start at the front/cab and place the rst clamp
6 to 9 inches (152 to 229mm) from the front.
Front/Cab
NOTE: Some drop in
liners may require
trimming in the corners
to t the rail tightly into
the corner of the bed.
If the truck
does not have
3
1
8
5
Make sure the
clamp is inserted
all the way up
into the rail and
clamp teeth are
aligned to the rail
slots to ensure grip.
1
0
1
0
- 3
0
With the tailgate closed, place the Xceed
rails on the truck bed rail with the slotted
bracket forward toward the
cab/front and facing inside.
Item No. 31851010-30 4.16.19 DD
Extang, Corp., 2019. Printed in USA
Advertisement
Related Manuals for Truck Hero extang XCEED
Summary of Contents for Truck Hero extang XCEED
- Page 1 The XCEED truck bed cover requires the installation of rails and some small parts. Note any damaged or missing components before installing. Tools required: 9/16” and 1/2” sockets and ratchet wrench, Phillips screwdriver It is important that With the tailgate closed, place the Xceed If the truck all areas where the does not have...
- Page 2 Place the 2nd clamp near Place the rear clamp approximately 6 inches the center of the rail. 152 mm from the tailgate. Tighten all the clamps to 10 ft-lb, 13,6 N-m. NOTE: Always apply downward pressure 10 ft-lb to the rail when 13,6 N-m tightening the clamps to ensure that the...
- Page 3 The cover’s aluminum frame at the tailgate should The rear edge of the cover and tailgate seal should rest on top just t inside of the tailgate when the cover is of the tailgate. The cover must also be parallel with the tailgate correctly positioned from front to back.
-
Page 4: Important Notice
IMPORTANT Bed cover safe operation and use IMPORTANT NOTICE While driving, the cover must be completely at and secure with all latches in the closed position OR completely folded up (all panels) and secured at the cab. DO NOT DRIVE with cover partially opened. T onneau Cover Positions While Operating Vehicle Strap Storage Position... -
Page 5: Replacement Parts
Replacement Parts NOTE: To order replacement parts, it is best to contact our Customer Service Department for assistance, to ensure getting the correct part for your vehicle application. When ordering, xxx represents the 3-digit sufx, as referenced on the sales receipt or vehicle application list. - Page 6 Extang offers three years of coverage from the date of purchase. Warranty is limited to original purchaser of truck bed cover and is nontransferable. This warranty is against defective materials and workmanship. The warranty is void if the product has been damaged by accident, unreasonable use, neglect, improper service/installation/removal, modifications, normal wear and tear or other causes not arising out of defective materials or workmanship.
Need help?
Do you have a question about the extang XCEED and is the answer not in the manual?
Questions and answers