Air Conditioning Mode; Dehumidifying Mode - DeLonghi AN Series Instructions For Use Manual

OPERATING FROM THE CONTROL
PANEL
Turning the appliance ON/OFF
Before plugging the appliance check the caps on the
back of the unit are correctly inserted and screwed on
the drainage hose 11.
Plug into the electrical receptacle. Two lines appear on the
display indicating that the appliance is in stand-by.
Press the ON/OFF button (A). When turned on, the air conditioner
starts operating in the same mode as when it was turned off.
Press the MODE button (B) until the light corresponding to the
desired mode lights up:
: Air conditioning symbol (G)
: Dehumidifying symbol (H)
: Fan symbol (I)

Air conditioning mode

Ideal for hot muggy weather when you need to cool and
dehumidify the room.
To set this function correctly:
• Press the MODE button a number of times until the air
conditioning symbol appears. Room temperature is
displayed.
• Select the target temperature by pressing the
(F) or button (C) until the required value is displayed.
During selection, the temperature flashes.
After 10 seconds, room temperature is displayed again.
• Select the required fan speed by pressing the
°F
°F
button
°F
button.
There are 3 speeds available:
High speed: to achieve the target temperature as
rapidly as possible
Medium speed: reduces noise levels but still
maintains a good level of comfort
Low speed: for silent operation
NOTE:
• The most suitable indoor temperature for the room during
the summer varies from 75°F to 81°F (24 to 27°C). You are
recommended, however, not to set a temperature much
below the outdoor temperature.
• When installing the air conditioner, you should leave a door
slightly open little as 1/2" (1 cm) to guarantee correct ven-
tilation and room pressure.

Dehumidifying mode

Ideal to reduce room humidity (spring and autumn, damp
rooms, rainy periods, etc). For this mode, the appliance should
be prepared in the same way as for air conditioning, with the air
exhaust hose attached to enable the moisture to be discharged
outside.
To set this function correctly:
• Press the MODE button a number of times until the
dehumidifying symbol appears.
PLEASE NOTE: In this mode, with room temperature above
77 degree F, the fan speed is adjustable. If the temperature is
below, fan speed is selected automatically by the appliance and
cannot be set manually.
°F
Fan mode
When using the appliance in this mode, the air exhaust hose
does not need to be attached.
To set this function correctly:
• Press the MODE button a number of times until the fan
symbol appears.
• Select the required fan speed by pressing the
High speed: for maximum fan power;
8
en
°F
button.
°F